pv ribbon -pre cut 0.23*1.5mm

Ref Price:
Loading Port:
Shanghai
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
339 ton kg/month
Inquire Now Customer Service

Contact us by

(1) WeChat
(2) Whatsapp: +8617190086776

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

1、基材参数Base Copper Parameter

铜基材Base Material

TU1 oxygen-free C10200

成分含量 Content

CU>99.97%

导电率 Electrical  conductivity

≥100% IACS

电阻系数Resistivity

≤0.017241Ωmm2/m

2、涂层成分Soldercomposition

涂层成分

Solder Type

涂层成分比例

Solder composition rate

单面涂层厚度(mm)

Solder Single Thickness(mm)

涂层厚度公差(mm)

Solder Thickness Tolerance(mm)

含铅

(Leaded)

Sn60%Pb40%

0.01-0.04

±0.005

Sn63%Pb37%

0.01-0.04

±0.005

Sn62%Pb36%Ag2%

0.01-0.04

±0.005

无铅(Lead-free)

Sn97%Ag3%

0.01-0.04

±0.005

其他成分比例可根据客户工艺要求定制Other  solder composition available according to customer’s technical requirement

3、产品几何尺寸及公差Physical Dimension and Tolerance

类别 Type

厚度范围及公差(mm)

Thickness Range and  Tolerance(mm)

宽度范围及公差(mm)

Width Range and Tolerance(mm)

长度及公差(mm)

Length Range and Tolerance(mm)

互联条

Interconnect ribbon

0.15-0.3 ±0.01

1-2.5  ±0.05

28-500  ±1

汇流条

Bus Bar

0.2-0.4  ±0.01

3-8   ±0.05

28-1205 ±1

其他尺寸可根据客户工艺要求 Other  Dimension available according to customer’s technical requirement

4Have the best match with cells andwelding machine.Deduct to the broken for cells.

5Also increases solderability andconductive,this also results in maximum output efficiecy from module


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:What are the forms of solar energy products
Solar heating, refrigeration, as well as solar panels with warm glass, heating room......
Q:Solar panels with single crystal silicon or good thanks
Working principle: sunlight to the solar cell plate produced by the current through the inverter controller of the battery, the battery power through the inverter controller into DC or AC electric power supply (load), or through the grid connected inverter of direct energy input power grid. Solar photovoltaic system consists of solar cells, solar controller, battery (Group), such as the output power for AC 220V or 110V also need to configure the inverter. In the specific design of system engineering, the following factors should be considered:1, the actual total power (load) and the use of time, should be reserved for the normal operation of the system;2, the local effective sunshine time, the proportion of rainy weather;
Q:Advantages and functions of solar energy
The advantages of solar energy: solar energy as a new energy, compared with conventional energy it has three major characteristics: first, it is the most abundant energy source. It is estimated that in the past 1 billion 100 million years, the sun itself consumes energy in the future 2%. is sufficient to supply earth, using billions of years it is inexhaustible, inexhaustible.
Q:Good solar polymer or monocrystalline
1, the actual total power (load) and the use of time, should be reserved for the normal operation of the system;2, the local effective sunshine time, the proportion of rainy weather;3, the local meteorological data, such as sunshine time, weather disasters, storms and so on;4, the construction site must be open, in the installation of solar cells can not be tall buildings or other things blocking the sun;
Q:Buy solar water heater mainly look at what?
Such a water tank, not only poor quality, but also may cause damage to the health of consumers with bacteria. Third, insulation layer. The quality and thickness of the insulation layer determine the insulation effect of the water heater. Now on the market most of the solar water heater using polyurethane foam insulation technology, but also the polyurethane material, but also the overall high pressure foam and low pressure foam. Large enterprises using the overall high-pressure foam to ensure the pressure and fullness of foam, a lot of small manufacturers of low pressure foam will be part of the insulation layer of the phenomenon of incomplete.
Q:Household solar energy productsThe product can be used at home, do not mention the solar energy, answer the water heater
Divided into two large photovoltaic and thermal.Photovoltaic power plant used in the battery board has two kinds of polysilicon and monocrystalline silicon, which is a little higher conversion rate. A solar photovoltaic system of solar power generation system, glass curtain wall, large on / off grid systems (e.g. Tibet Yangbajing engineering). In addition, there are solar street lights, scenery complementary street lights, solar lights, solar LED screen, solar backpack, etc.
Q:What about solar products?Solar panels solar panels
As long as the need to get electricity can. Solar lamp (lamp, landscape lamp, lawn lamp, flashlight, camping lights, lights and so on...), power generation system (Canada now many private power, is the placement of solar panels in the roof)...
Q:Solar garden lamp product parameters
* main body material: the lamp post is full steel structure, whole hot galvanizing / plastic spray treatment* solar modules: crystalline silicon 15-80WP (by load configuration)* operating voltage: DC 12V - 24V* controller: solar lamp controller, light control + time control
Q:The steps of making solar technology stubs
1 with a brush clean eraser material: big eraser, waste brush.Tools: scissors, glue.
Q:What are the third generation solar cells
The physical connotation contained in it is: should keep the advantages of the second generation thin film solar cell with low cost, and is much higher than the Shockley-Queisser limit (32.8%) high efficiency, stable and reliable performance and the battery and battery rich material sources. In other words, the so-called third generation solar cell is a kind of high efficiency, low cost, long life, non-toxic and high stability of the near ideal photovoltaic solar cells."

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range