Q:How does the rotation of the CNC lathe and the feed per minute?

Then converted into per minute feed is 600X0.1 per minute is 600MM.

Q:What is the degree of taper 1:10 in the lathe drawings? How many degrees are there on the lathe?

Taper 1:10 The slope tangent function is 0.05,

Q:The difference between machine tools and lathes

In addition to cutting, there are casting, forging, welding, stamping, extrusion, etc., but those who require high precision and surface roughness requirements of the smaller parts, generally need to be in the processing of mechanical parts,

Q:Slip the difference between machine tools and CNC machine tools

The control system can logically process a program with control codes or other symbolic instructions and decode it, digitally represented by code, and input to the numerical control device through the information carrier.

Q:Who will use a hexagonal lathe

Instrument lathe to change the spindle to the knife to the knife, the knife has a gearbox on the chuck card in the workpiece rotation, line into the ratio!

Q:What is the top of the lathe and the classification

1) Front of the front of the lathe can be directly installed in the lathe spindle cone hole, the front tip and the workpiece with the rotation, no relative movement, so no need to quench.

Q:Lathe and lathe workers is not a meaning

Workpieces are: lathes, knives, gauges, blanks, finished stacks, and other accessories.

Q:CNC lathe gear box sound how to do? The The

1) Check the quality and level of the oil in the tank is normal, if the quality is not good to replace the new oil, if the liquid level at the end of the required to add the required level.

Q:How is the turning of the lathe?

1. Use the outside garden turning tool to test the outside of the park, remember the current X coordinates, measure the diameter of the outside garden, use the X coordinate minus the diameter of the outside, and enter the value of the offset interface in the X value.

Q:What is the material of the lathe tool?

High-alloy steel, there are 40Cr, the poor manufacturers replaced with 45 steel, cheap but rigid!