Q:How much is the voltage across the 20 LED lamps in series?

Each LED is about 3V, and the 20 series is 60V

Q:The top LED lights always burn the bulb in series

A simple circuit based on resistance current limiting can only be adjusted with current resistance.

Q:Section LED lantern, no controller, can shine principleTwo now reduced brightness string string

Led 2 polar tube inside chip oscillator circuit, and the general appearance led 2 polar tube without distinction, only connected to the power supply of two kinds of color turns light, 1 seconds, I bought the 5MM red, blue autoflash. From the appearance of the series, but not necessarily in series

Q:220vled water lamp string how to connect, that is, 220 of the electricity

On the way of C1, R1, L1, R2 varistor, the primary power supply filter circuit, can input the instantaneous pressure filter, C2, R2, C4, C3 step-down circuit, L2 varistor and filter circuit is composed of rectifier, the filter, which can effectively protect the LED by high pressure breakdown.

Q:What's the price of the LED light string?

Light guide plate and diffuser plateLED panel lamp manufacturer's production line price is probably between 60-80 yuan (12 pieces). The quality of the light guide plate is one of the most important factors determining the quality of the LED panel lamp. The use of high-quality light guide plate can make the finished LED panel light more uniform. No dark spots, ripples and so forth

Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!

You can use the 4~6V battery, through the 4W, 2~3 Europe (6V with 3 Euro, 4V with 2 Euro) current limiting resistor, to the LED lamp power supply. The parameters of each lamp are: 3V, 20MA, in parallel (polarity). If you don't quite understand, you can also ask a science and engineering student (preferably a teacher) to help.

Q:Led full-color light string and how to control wiring

5 line DMX512 full color string, 2Po, 2 access, and access control site

Q:How do you connect the LED lights?

Connect the bottom edge of the triangle symbol to the high voltage and the sharp angle to the low voltage. The bottom edge of the next LED is connected with a sharp angle

Q:How does the LED light string flash?

Because of the special volt ampere characteristics, LED can not use constant voltage driving mode, but is driven by cross flow. The direct drawback of cross flow drive, however, is heat. So people invented the drive mode of pulse drive. For example, 0.5 seconds per second, so that the amount of heat in the LED is reduced by half. Then turn the frequency up to 100 times per second, lighting for 0.005 seconds each time. At this point, the power of the LED is not the same, and people do not feel blinking. What's more, in this driving mode, an approximate cross flow drive (that is, the current is not necessarily precise) can be simplified, which simplifies the drive circuit (the precise cross flow source is very complex)

Q:Why are there three lines for the controller of the LED light string? What are they?

The four cycles are green, blue and white, and the answer is almost the same as that on the top. But the three colors are strung together