Q:What kinds of tables are there? Which is better for the office?

Lift table many brand, currently on the market the main lifting table is divided into: electric hoist, mechanical lifting table (barometric, mechanical lifting), electric lift table when the disadvantage is that there was no electricity can't use our company with polly lifting table, manual lifting regulation, any place to stay, very effort; And it can move back and forth

Q:Is there a replacement for similar elevating functions?

This is not a press machine, a wacky experiment, a big nail in the press, and how much pressure to puncture a tyre.

Q:What should the chain's main elevator be aware of when installing the chain

The rail link elevator usually requires a design pit. For equipment and the ground level factors, design should be carried out in accordance with the actual demand design pit size, at the same time when the production equipment shall be carried out in strict accordance with the size of the pit production.

Q:Tomb raider 9 research base elevator to go to go to go to go to the order to pry the gear not to go down to go down to go down the card 3 to break up

There are four of them, four of them. See the white climbing wall outside the elevator? Find a way to burst open a hole in the iron wire and climb to the fourth gear. There was no order in this gear, four of them were done, and the elevator fell down.

Q:There are different kinds of milling machine and vertical lifting machine milling machine

Horizontal milling machine also can use the above all kinds of cutting tools, but not as convenient vertical milling, mainly can use the rack cutter (mainly side and face milling cutter, flake cutter, etc.). Milling tank, milling plane, cutting etc

Q:Do you have a personal elevator with hydraulic platform

Hydraulic platform itself is not flat layer device, the upper and lower limit is oil cylinder and the mechanical structure limits. Platform only "motor" "stop" "up" "down" button. The safety of the sheared platform can also be shaken when it starts and stops, without the thought preparation. In different floor installed several travel switch, electric cabinet, become automatic stop, hardware does not need how many money, the line a little trouble. Can do it. Just installed is not good

Q:How do you remove the horizontal universal elevator milling cutter

When the milling cutter is removed from the vertical milling machine, the lever nut must be released and then the end of the rod is gently tapped. ; You should not release too much, as long as you have some loose space. When you release too much, the thread connecting the rod and the milling cutter is too short, and when you tap, you slip and even drop the knife.

Q:What can be done when the hydraulic platform is down?

You can't see your schematic diagram, theoretically do not use hydraulic lock, should balance valve, the frequent switch of hydraulic lock causes jitter and unstable. Shunt valve, speed regulating valve or pressure compensating valve is a common solution to solve synchronization problem. Synchronous diverters are expensive

Q:How to automatically lift up and lift

The motor is controlled by a time relay, the motor is driven by a change of speed, and when it falls in place, it meets the power failure of the limit motor

Q:What is the price of the hydraulic platform

Price is not uniform, see what you want to do. We are also on the platform, the price has not been raised.