Double Sided Tape for Rain Guards - Double Sided EVA Foam Tape DSE-10YM
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
CONSTRUCTION:
Backing: EVA Foam
Adhesive: Hot melt rubber adhesive.
Liner: Yellow/white paper
TYPICAL PHYSICAL PROPERTIES:
Total Thickness (adhesives + backing): 1 mm
180° Peel Adhesion: more than 1.5 kgf/25mm (to steel)
Holding power: not less than 50h
Temperature resistance: 60DC
Elongation: 50%
Sizes:
Jumbo Roll: 1020mm x 300m
Cut Roll: As per customer’s requirements
REMARKS:
1. The data above are typical results and subject to change without notice.
2. Tolerance: Weight and Thickness: ±10%; Width: ±3mm;
Length: Cut Roll & Log Roll ±0.3m, Jumbo Roll ±0.5%.
3. The products should be stored at room temperature and be kept away wet and/or heat source.
4. It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, and free of grease and oil.
5. The users should take test and do trial-application on the above products before coming into application so as to witness and ensure suitability for their special purpose and technique.
- Q: The door frame is glued on both sides of the curtain. Now the curtain doesn't work. It can't be cleaned on both sides. How can it be removed? But it doesn't break the paint on the door It's a little bit on the wall, too.
- It can be removed quickly with medical alcohol. Steps are as follows:1, ready medical alcohol, cotton swabs and dry cloth, medical alcohol and cotton swabs, pharmacies have to sell, the family needs spare things.
- Q: How do you apply double-sided adhesive tape?
- 7, in the printing process to clean the printing plate, should avoid cleaning solvents, contact tape, so as not to damage the tape;8 when the plate is removed from the tape, the angle between the plate and tape shall be no more than 90 degrees.9, the interface version of the place to stay 5mm or so, the use of 3M 1600 electrical insulation tape seal version of the effect is good, you can effectively avoid wiping the plate caused by the interface version of the resulting ink pollution, and very economical.10, double-sided adhesive over repeated use can produce overprint bad phenomenon, especially in the new situation, and used for a long time in registering are likely to happen.
- Q: Do you really think your tape is good?
- If the price is very low, the quality is often not guaranteed
- Q: In the production process of cotton double-sided tape winding unevenness is what reason
- Back paper smoothness and with or without moisture.The above situation may occur when the volume of winding is not smooth, pay attention to observation when gluing,
- Q: Will double face adhesive affect its stickiness in summer?
- Quality inspection of double sided adhesive tape:1, check whether there is a crack on the double-sided adhesive tapeDouble sided tape in slitting, if the cutting tool adjustment is inappropriate or the blade is not sharp, will be in the double adhesive tape on the surface or bottom paper cracks, cracks at the pull out of the fiber will be adhesive stick. The occurrence of cracks may be continuous, may also be random, may appear in the side of the double-sided tape reel, may also be on both sides, so, double-sided tape processing, not to look carefully at the end of the paper and paper on whether there is a small crack.Then, take a piece of paper that has been checked, peel it off the bottom, and check again whether there is a crack on the bottom and the bottom of the paper, because the crack is sometimes very small and can only be found after separating the base paper and the tissue.
- Q: Home decoration, with a thick foam tape to bring a whole stick that hook,It's all right now. It's falling all the time,Now to clean up, how can clean up?
- 3, with Fengyoujing rub, then dropped.4, you can try a rubber. But in the beginning may feel more and more dirty, but rub a little longer, you will see the effect, this method is relatively tired, have perseverance.5, with blisters, put a little detergent, and then brush with an old toothbrush just fine.
- Q: Double face adhesive and what material do not stick?
- In addition, there are epoxy resin, orange peel paint, some anti rust paint, Polyflor board, fire board, some tiles, and so on.
- Q: Double sided with sun flower on the center console of car?
- Very simple, you get some industrial alcohol, with a rag to kill, not to engage in alcohol directly with dishcloth Zhanshui rub slowly, do not worry, multi wipe, double-sided adhesive will remain in a heap, and then wipe off with hands as well.
- Q: Construction method of butyl adhesive tape
- Single sided non-woven fabric, Yongxing adhesive tape, method of use(1) after the lighting board is installed on the frame, the lighting board seam will be bound and the parts of the adhesive tape will be wiped clean.(2) open the adhesive tape in the joint of the lighting board, then tear off the insulating paper on the edge of the compacted adhesive tape, and then install the aluminum alloy board on the lighting board. Secure with a waterproof screw.(3) on the lighting board and the wall joint, use one side aluminum foil adhesive tape to bond directly. 1, construction requirements(1) the performance indexes of tapes should be read carefully before construction so as to be suitable for the environmental temperature and humidity during construction.(2) according to different waterproofing membrane, different construction methods, choose different types, specifications of different sizes of Yongxing tape.(3) before construction, the quality of the aforesaid project shall be checked and accepted, and the waterproof layer shall be constructed after qualification.(4) according to the requirements of the engineering design and construction waterproofing, waterproofing and leveling layer bonded firmly, do not allow Konggu phenomenon, after the construction of waterproof layer should be protected.(5) the use of Yongxing parapet should pay attention to the tape, brick or concrete surface bonding parts of the firm and smooth surface, such as the poor, the application of cement paste for repairing yarn
- Q: 5 cm double sided glue. How many meters per roll?
- Suggest to Taobao or Ali look for related manufacturers. Ask for specific information.
Send your message to us
Double Sided Tape for Rain Guards - Double Sided EVA Foam Tape DSE-10YM
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
Hot products
Hot Searches
Related keywords
