Double Sided Tape 18mm - Double Sided EVA Foam Tape DSE-20YM
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
CONSTRUCTION:
Backing: EVA Foam
Adhesive: Hot melt rubber adhesive.
Liner: Yellow/white paper
TYPICAL PHYSICAL PROPERTIES:
Total Thickness (adhesives + backing): 2 mm
180° Peel Adhesion: more than 1.5 kgf/25mm (to steel)
Holding power: not less than 50h
Temperature resistance: 60DC
Elongation: 130%
Sizes:
Jumbo Roll: 1.02 x 200m
Cut Roll: As per customer’s requirements
REMARKS:
1. The data above are typical results and subject to change without notice.
2. Tolerance: Weight and Thickness: ±10%; Width: ±3mm;
Length: Cut Roll & Log Roll ±0.3m, Jumbo Roll ±0.5%.
3. The products should be stored at room temperature and be kept away wet and/or heat source.
4. It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, and free of grease and oil.
5. The users should take test and do trial-application on the above products before coming into application so as to witness and ensure suitability for their special purpose and technique.
- Q: How do you remove the sponge double glue on the wall?
- 1, with eraser along the edge of a little to rub inside, easy to trace. But depending on how sticky you are, it may vary in time. If conditions permit, the alcohol + eraser works very well2, you can take a piece of vinegar coated dry cloth to cover the entire double-sided glue mark place, and until the double-sided adhesive after soaking wet, you can easily remove with a ruler.
- Q: How do you apply double-sided adhesive tape?
- 7, in the printing process to clean the printing plate, should avoid cleaning solvents, contact tape, so as not to damage the tape;8 when the plate is removed from the tape, the angle between the plate and tape shall be no more than 90 degrees.9, the interface version of the place to stay 5mm or so, the use of 3M 1600 electrical insulation tape seal version of the effect is good, you can effectively avoid wiping the plate caused by the interface version of the resulting ink pollution, and very economical.10, double-sided adhesive over repeated use can produce overprint bad phenomenon, especially in the new situation, and used for a long time in registering are likely to happen.
- Q: What are tapes and hot melt tapes?
- Rubber tape glue is rubber as the main material, the main emphasis on grey black color.Hot melt glue cloth tape with resin as the main base, mainly yellow and white color bias.
- Q: What are the general use of double-sided tape?
- Oily double-sided adhesive, mainly used in leather goods, pearl cotton, sponge, shoes products, such as high viscosity. Embroidery double-sided adhesive mainly used in computer embroidery.Computer embroidery special, sticky strong, repeated use more frequently.
- Q: The mirror is glued to the glass door with double adhesive tape. How can the mirror be removed?
- The electronics factory often uses something called "sky water", which I have used
- Q: Do you really think your tape is good?
- If the price is very low, the quality is often not guaranteed
- Q: Home decoration, with a thick foam tape to bring a whole stick that hook,It's all right now. It's falling all the time,Now to clean up, how can clean up?
- 1, wipe the face oil coated, and wipe evenly, first use the nail to cut him off, and then take a wet towel, wipe off.2, use the hair dryer blow, the glue baking heat can be got down.
- Q: Construction method of butyl adhesive tape
- The joint of profiled steel sheet and cement wall is leaking(1) remove all the original silicone glue from the profiled steel sheet and the cement wall joint;(2) and then press the steel plate and cement wall joint clean; requirements of cement metope can not rise sand, there isConditions should be painted base treatment agent.(3) the joint of the metal plate and the cement wall is adhered with one side aluminum foil, and the Yongxing adhesive tape is pressed and repaired according to the orderMake the Yongxing adhesive tape of the single face aluminum foil bond firmly at the joint.(4) daylighting board roofing construction method.
- Q: How to remove double adhesive on paper?
- Another piece of paper by hand with double-sided adhesive pressed together, gently from the original paper on the double glue opened a nod, and a piece of paper then pinched together, slowly can put off the double-sided adhesive from the original paper.
- Q: How can I use double-sided adhesive tape? I glued it for half a day without sticking it
- Tear off the required length, and then use fingernail scratch tape attached to the bark, peel can paste.
Send your message to us
Double Sided Tape 18mm - Double Sided EVA Foam Tape DSE-20YM
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
