Q:What are the 3M double-sided adhesive?

Foam material double sided adhesive (made of foam base material, double coated with acrylic rubber): such as 3M4920, 3M4026, 3M4032, etc.;Hot melt adhesive film: such as 3M615, 3M668, 3M669 and so on;High temperature adhesive tape: such as 3M244, etc..

Q:How do you apply double-sided adhesive tape?

4. The joint of the double adhesive tape should be staggered with the joint of the plate;5, with adhesive tape, it is best to use rubber scraper, in a parallel sweep way, the tape evenly affixed to the roller, in the tape and the roller can not leave the bubble; (if the bubble retained, the application needle punctured)6, in determining the location of the printing plate, should avoid the printing plate and tape premature contact, to determine the printing position, remove the tape protection layer, the plate with rubber roll, in parallel with the way on the adhesive tape;

Q:What's the material of PE foam double release tape? Urgently!!

Is from the type of paper or film or paper is paper? Gerasin coated silicon film, release film is called red film green film, the material is PE.

Q:How do you remove the double adhesive tape on the towel? Sticky very tight ~ ~ how to do?

1, with eraser along the edge of a little to rub inside, easy to trace. But depending on how sticky you are, it may vary in time. If conditions permit, the alcohol + eraser works very well2, you can take a piece of vinegar coated dry cloth to cover the entire double-sided glue mark place, and until the double-sided adhesive after soaking wet, you can easily remove with a ruler.

Q:PET what's the advantage of double-sided adhesive?

Can be applied to a wider range of temperature and harsh environment, such as Shanghai Yao adhesive tape factory produced PET double-sided tape, there is a good initial viscosity and viscosity

Q:What is an engraving tape?

1., using high strength synthetic rubber as base cloth, strong toughness, not easy to break

Q:There is double adhesive mark on the back shell of mobile phone. How can I clean it up?

2, with an eraser along the edge of a little to rub inside, easy to trace. But depending on the degree of viscosity, time may vary. The alcohol or eraser works very well if you have the condition.

Q:Especially for tape demanding products or areas, it is best to import adhesive tape industry, thank you!

Some need strong adhesive force, such as advertisement, door industry, clothing printing, etc.. Some face to withstand high temperatures, such as electronic and electrical equipment industry, automotive industry. If you want to do it, you must understand your product performance.

Q:How to preserve PET double faced adhesive?

This can save for a while. If it has been spread out, load it inside the carton and seal the tape as it is. Plastic bags are not allowed.

Q:Our products are: epoxy resin paste in a stone covered with oily double-sided adhesive on a piece of paper is now seeking a double-sided adhesive viscosity usually general once heated or after processing high viscosity glue or waterproof solid can be bent double surface adhesive heat Sol can be replaced with paper printing cloth for double-sided glue for I called 6 glue edge die without affecting the effect of have a heart

You can use this one HY-T119 glue to adhesive bonding, before curing is not sticky, after curing has good strength, good toughness and bending, how how to fall is not out of the key is non-toxic glue, colorless and tasteless, environmental protection and easy to use