Q:LED lights string broken, how to repair?

Connect the electricity. Can be shorted one by one. It's shining. This is just short of bad beads.

Q:What is the connection distance of the LED light string?Be specific

The connection distance is 15 meters. If the connection distance is exceeded, the LED light string is easy to heat, and the service life of the LED light string will be affected during use

Q:Section LED lantern, no controller, can shine principleTwo now reduced brightness string string

Led 2 polar tube inside chip oscillator circuit, and the general appearance led 2 polar tube without distinction, only connected to the power supply of two kinds of color turns light, 1 seconds, I bought the 5MM red, blue autoflash. From the appearance of the series, but not necessarily in series

Q:220vled water lamp string how to connect, that is, 220 of the electricity

The time of the water lamp is controlled by adjusting the capacity value of the capacitor.

Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!

If it is a general common blue LED working current is 20 mA, voltage of about 2.5V can be lit, the battery power can be used in parallel, the benefits of this connection is one of the damage does not influence the normal operation of other LED. And each LED string to a current limiting resistor, LED protection lamp, prolong life, calculation formula of the resistance for V / 0.02A=: voltage current resistance: 3V, battery powered =3 / 0.02=150. You want to supply 55 LED batteries to work together, the total current is up to 0.02x55=1.1A, i.e. 1AH (ah) capacity of the battery can work 1 hours or so.

Q:The color temperature of LED light string

Generally speaking, the color temperature is not an indicator of the LED band, but many foreign customers will make a special request because of the use of the environment.

Q:How do you connect the LED lights?

A series of even parallel. Are not clear, boss, you want to use LED do what?There is a gap, which is the positive pole of the LED (usually the long foot is short and the foot is negative)

Q:What are the power connections for the LED light string?

If you do not want to use a power to control each LED lamp string, can switch power to buy a relatively large power for the total power supply, then put all LED light on the input power (all parallel wire size is not enough, can also extend) unified by the total power switch.

Q:Why are there three lines for the controller of the LED light string? What are they?

The LED pipe positive string is connected with 4-5 1K2W resistance strings, and the other end of the resistor is connected with the common positive pole of the controller. LED tube controller's direct bright output (Huang Xian), if the LED tube brightness is not too bright, minus a resistor. Remember not to short-circuit, short-circuit, burn out the controller. The less string LED, the more resistance string.

Q:Example: if I want to do a 40 head low voltage lamp string, do 10 lights, 1 loop, transformer is 150MA, then how can I calculate the resistance? The grid is 60 Hz of China's power grid! Give a formula, and then count the examples. What is it?! Thank you

If you direct the transformer to the LED lamp power supply, the life of the LED lamp will be affected, far less than the nominal value.