Q:What is the reason for the movement of light in the tube

Individual new lamp tube is lighted when this phenomenon, say to roll, can be used normally, multiswitch after a few times to observe, general will disappear. Brightness is related to voltage, ballast power.

Q:How to connect the power supply when the LED lamp is energized? The search is to get a wire directly from two ends? Do you need to be able to distinguish positive and negative?

Well, there is no such thing as a positive negative, you can just put it on the shelf, and if it's unique, just plug it into the socket

Q:The LED fluorescent tube plus the ballast why is it still going to press?

Use neon bulb discharge heating bimetallic strip in open and close, cause inductance ballasts and generate high voltage pulse electric current mutations on both ends of the lamp and ballast used in fluorescent originally when the above is to make haste to booster.

Q:Can the LED tube be installed as a general lamp holder? It won't burn easily

LED lights need dc power, so the two end of the frame are dc output And the lamp tube needs to communicate electricity, dc is to damage the lamp directly

Q:Excuse me, the lamp in the sitting room lamp is carried good or the lamp tube is good

Lamp band light is uniform. Lamp tube is broken and can be replaced. Lamp band must be changed. Direct selection

Q:How did the new daylight tube ring

It's a light tube problem, but it doesn't matter, you don't want to worry about him in a few days.

Q:The two ballast that originally was electric inductance towed three ordinary fluorescent lamps, now changed to LED fluorescent lamp tube, have influence?

Remove the inductance ballasts and qi, a lot of LED power supply does not support the front with ballast, if adding the ballast, this product may cause permanent damage to the product. Besides, it is energy efficient in itself, why would you add a ballast in front of you? Just cut it off and OK.

Q:But what happens when you don't take a ballast and replace it with a traditional fluorescent lamp?

This can also be bright, but it's also a waste of electricity and some of it doesn't have a flash of flash and it's going to light up in a flash

Q:Are led fluorescent tubes not available for lighting?

But to see if there is a built-in power source, the external power source is not directly 220V,

Q:Now the home decorates is to use LED good or the good of the lamp tube

Hello, because LED lighting is a trend, now the domestic market is more than 10%, and now the main business and road are driving faster, LED lamps and traditional lamps and lanterns compare to have comparative advantage energy-saving, environmental protection, high efficiency, long life, no screen flash, no ultraviolet light It is suggested that LED lamps should be used for the following traditional lamps