Aluminum Foil Tapes without release liner T-F4004WWL

Ref Price:

Loading Port:: Shanghai

Payment Terms:: TT OR LC

Min Order Qty:: -

Supply Capability:: -

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Phenolic HVAC air duct board

Phenolic air duct insulation board environment friendly

Aluminium Flexible Duct Ventilated Flexible Duct for HVAC

Insulated Aluminium Flexible Duct

Combined PVC Flexible Duct

Aluminum Foil Tape with Release Paper TS-2401

Uninsulated Flexible Ducting Insulated Flexible Ducting

Aluminum Foil Duct Tape with Water Based Adhesive

Water-based acrylic Aluminum foil tape:

A aluminumfoil with water based acrylic adhesive. It has good adhesion. Ideal forwind-pipe’s heat preservation of refrigerator and air-condition.

Carrier:

Aluminum foil,40micron and 108 g/m²

adhesiveglue:

Water base acrylic, weight 36±2 g/m²

PHYSICAL PROPERTIES:

Description	Units	Value	Test method
Tape thickness	mm	0.078mm±10％
Adhesion to steel	N/25mm	≥10N	GB2792-1998
Tack	#	32#	GB4852-2002
Holding power	Hours	≥48h	GB4851-1998

Aluminum Foil Tapes without release liner T-F4004WWL

Q: If I feel the room cool off, one hour hot and open an hour this will be more expensive? More: Common scaffold brace is the U-type care, "construction of fasteners steel scaffolding safety technical regulations" (JGJ Gong Gong Duo Ji-tao pan Revenge two 130-2011) provides "adjustable support bearing capacity design value is not Should be less than 40kN, the support plate thickness should not be less than 5mm ", the general calculation using 30kN.

Q: Air to water heater host and air conditioning host is not the same: This test with a small sample length 127mm, width 12.7mm, the maximum thickness of 3.2mm. In the absence of ventilation test chamber. The top of the specimen (6.4 mm place) is clamped with a clamp on the bracket and the longitudinal axis of the specimen is kept vertical. The lower end of the specimen is 9.5mm from the lamp tip and 305mm from the dry absorbent cotton surface. Bring the Bunsen burner and adjust it to produce a blue flame with a height of 19mm. Place the Bunsen Lights flame at the bottom of the sample for 10s, then remove the flame (at least 152mm away from the specimen) and write down the sample. Burning time. If the flame of the sample within 30s after removal of the flame is extinguished, the original lamp must be moved under the specimen again, re-ignite the sample for 10s, and then remove the Bunsen burner again and note the flame burning And flames burning the burning time. If the sample droplets drip, let it fall into the sample under the 305mm cotton, to see whether it ignited cotton. If the absorbent cotton is on fire, the rating should be taken into account. Specific grading indicators are as follows. Test Item 94V-094V-194V-21 Ten-time ignition Total flame burning time Maximum value (S) Individual flame burning time Maximum value (s) Flameless burning time (s) Yes Flame drop No No Allow only short time Burning general UL yellow card on the thickness of the test strip is divided into: 1/8 inch, 1/16 inch, 1/32 inch thickness, that is, 3.2mm, 1.6mm, 0.8mm three grades test.

Q: Air conditioning ventilation when the sound is a big reason: According to my specific circumstances, in the following seven major hazards include the division, sub-project focus on control

Q: US direct mail dysonhp01 Dyson air purification cooling machine triple in the country to warranty it: Among them, the extruded polystyrene gypsum composite board is based on paper gypsum substrate, the use of adhesive and extruded polystyrene board through the factory processing compound

Q: Gree air conditioning 50 heating and cooling mechanism heat when the host cooling network is how the matter: Can be small, according to your roof to do what material.

Q: Air conditioning machine work when the sound is too much reason: This is based on the density of benzene board decision, not what you said, know it buddy.

Q: What is the whole heat exchange fresh air ventilator?: Depends on the main control panel is not cold and warm, single cold common motherboard. Only a generic motherboard can be changed. In the single cold air-conditioning on the outdoor machine to install the appropriate specifications of the four-way valve, adjust the amount of refrigerant to the appropriate level can be.

Q: External wall insulation method of operation There are several combinations of materials: 30-150 per square meter has, mainly to see the material, thickness and so on

Q: The installation method of ordinary air conditioner. The more detailed the better. Please thank you all: 2.1.23 step distance liftheight the distance between the upper and lower horizontal axis of the axis of each other. 2.1.24 pole vertical (cross) distance longitudinal spacingofuprighttube Scaffolding vertical distance between adjacent rods. 2.1.25 Vertical distance transversespacingofuprighttube Scaffolding Horizontal distance between adjacent vertical rods, single row scaffolding for the outside pole axis to the wall distance.

Q: HVAC Heating: What are the main components of the air distribution system?: The reasons are the following: 1. Household electricity is not enough, can not start the compressor, so in the heating state can only be ventilated state, cooling the state directly jump electricity; 2. See if you are reported failure, Code to determine the need for on-site inspection in order to know the specific situation; 3. Four-way valve should be no problem, do not just believe that this is the problem Oh; help your words to adopt

Send your message to us

*Email

*TEL

*Quantity

*Unit