Led Strip Light Fittings

Hot Products

FAQ

Led how to install the light belt?
Please don't light the band when the 1.LED light is in a roll.2., only on the lamp belt with a scissors mark on the body to cut, otherwise it will cause a unit is not bright.3. installation, please bring light bent to one side, exposing the 2-3MM copper wire, and wire cutters cut clean, there shall be no burr, avoid short-circuit.
What's the function of the LED band drive? Can I use the drive?
The working voltage is DC voltage LED lamp with a certain value, and the power is AC voltage within a certain range of fluctuation, therefore LED lamp belt should be stable and reliable work, must drive through the DC voltage alternating current into the fixed value. If you don't drive it directly, the lights will burn out instantly.
How long is the life of the LED light belt?
General domestic lamps 1 years began to decay, but also to see the current situation of using the circuit and chip
LED what does the band add to change colors?
If it is an ordinary monochromatic light belt, you can not change colorYou can meet the following conditionsYour light belt must be double chip, one is three wire, downstairs brother said, and another is 2 wire
LED lamp belt installation uneven lighting, how to do?
1, LED wait in the lamp slot is not fixed, that can only find the right size of the lamp belt, the lamp slot is estimated not to change.2, play out uneven light, light tank design may be reasonable, so that the light can not be evenly distributed, but also may be your lights with power supply is irrational, should use a constant current source, the lamp band will shine evenly.
What's the difference between a LED light strip and a light strip?
With lights, others will be included in the LED soft light in this category, but also includes some flat three lines, flat four line, used for plug-in lamp lamp series, after welding, injection molding process, body is bigger than LED soft light, used for outdoor lighting, the waterproof performance is good, but can not reach the brightness the brightness of LED soft light on the lamp.
How does the LED band replace the tube?
After all, there is a gap between the brightness of the tube and the brightness of the band.In lieu of words, may not achieve the original effect;With lights with high brightness, then only about 20-22lm/;With a high brightness light, or can not be compared with the high brightness of the tube
LED lamp and lamp with high and low points?
I don't understand what you say,The normal white light source is the basic 3V to light, if you give a 2.7/2.8V or to light up, but if you give a 1.5V is absolutely not bright,It depends on his volt ampere characteristics,We should look at how much light with a lamp, and on a few a few,