Quick Details of Three High-pressure Steel Braided Hose
Place of Origin:
Specifications of Three High-pressure Steel Braided Hose
Executive Standard:GB/T3683-92 MT98-84
CONSTRUCTION:This hose consists of an inner tube of oil synthetic rubber,three wire braid reinforcements,and an oil and weather re-sistant synthetic rubber cover.
APPLICATIONS:Hose range suitable to carry hydraulic fluids such as gly-col,mineral oils,fuels,lubricants,emulsion,hydrocar-bons etc.
The Technical Parameters of Three High-pressure Steel Braided Hose
Inside Diameter mm
Reinforcement Diameter (mm)
Outside Diameter (mm)
Work Pressure (MPa)
Proof Pressure (MPa)
Packaging & Delivery
Package: plastic films, then wrapped with fabrics
According to the Quantity
- Q:What is the essential difference between natural rubber and three yuan ethylene propylene rubber?
- The electric property of natural rubber is a kind of non polar material, and it is a better insulating material. When the natural rubber vulcanization after the introduction of polarity factors, such as sulfur, accelerator, so that insulation performance.The dielectric properties of natural rubber are a nonpolar substance that is soluble in non-polar solvents and non-polar oils. Natural rubber is not resistant to cyclohexane, gasoline, benzene and other media, non vulcanized rubber can be dissolved in the above medium, vulcanized rubber swelling. Natural rubber insoluble in polar acetone, ethanol, more insoluble in water, resistant to 10% hydrofluoric acid, 20% hydrochloric acid, 30% sulfuric acid, 50% sodium hydroxide and so on.
- Q:Can high speed air flow through a rubber tube and produce static electricity?
- To solve this problem, I suggest you do not focus on the voltage level, but focus on how to eliminate static electricity. For example, choose a low resistivity rubber material to ground and control the airflow humidity (if possible).If you really need to accurately grasp the size of the voltage caused by static electricity, and there is no reference to the literature, you may as well begin to study the experiment.
- Q:How long is the service life of the gas hose?
- The gas hose is connected to the gas pipeline and special gas hose with / out, according to the number of gas accident statistics analysis, because the gas hose aging or bitten by rats caused by gas leakage accident / Xi accounted for more than 30% of all gas accident.
- Q:What kind of material does hose screw protection cover have? What are their advantages and disadvantages?
- The utility model relates to a pipe protecting sleeve, which is a new product replacing the traditional metal protecting spring used for the protection of traditional rubber hoses. Alias: hose sheath, rubber tube outside protection special nylon spiral sheath, etc..
- Q:Installation of rubber flexible joint
- The pipe must have a fixed support or fixed bracket, and the force of the stationary bracket must be greater than the axial force. Vertical installation and overhead installation products both ends need to install the corresponding fixed bracket and force support, to prevent the compression of.
- Q:What are the matters that should be paid attention to when installing rubber hose joint in water pump?
- Know the rubber pipe joint is also called rubber joints, with vibration and noise reduction effect in the pipeline, and if used in water pump, so its main function is to prevent the suction flat and bear short time pressure, avoid water pump power and vibration and suction pipe bottom swing, the uniform flow and promotion in addition, the pump power consumption is reduced, because the rubber joint wall vertical groove, and prevent the vortex pump water, thereby improving the efficiency of water pump.
- Q:Access toilet water inlet hose joints, how to repair water?
- You try to put the connector aside, hold some force in the toilet hole, or add a person to press it with your hand, then swivel the pipe joint and maybe open it.
- Q:What is the difference between the precast beam of the bridge and the method of pulling out the rubber tube after pouring the concrete? What's the difference between design and calculation?
- Construction process, in order to avoid concrete into bellows, influence later wear steel strand, construction units generally use PVC and other rubber tube into bellows, in order to double insurance, don't let concrete into. Its length is certainly larger than the length of bellows (750mm at one end for easy operation)
- Q:What are the rubber pipe joints perfectly joined to the pipe fittings?
- Rubber tube joints are flanged in general. Thread.
- Q:The basic buret is a rubber tube is inlaid with a glass bead to replace glass piston. Why this burets cannot be used to install Potassium Permanganate solution?
- The rubber tube can be Potassium Permanganate oxidation
CYTRUBBER, specially produces wire braided rubber hose,spiral rubber hose,super high pressure rubber hose,pneumatic hose,sand blast hose,oxygen blowing hose,drilling hose,hydraulic cylinder,metal hose and various rubber products.With the merits of high pressure resistance,small bending radius,strong fatigue resistance,long lifespan and so on,our products are widely used in metallurgy,oil drilling,engineering machines,mining,various hydraulic machines and etc.
1. Manufacturer Overview
|Annual Output Value
||Above US$ 1.5 Million
||Mid East, Africa, Europe, America
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
||English; Chinese; Spain; Alabic
||Above 15,000 square meters
|No. of Production Lines
||OEM Service Offered; Design Service Offered
|Product Price Range