small diameter hydraulic hose clamps

Ref Price:
$0.03 / pc
Loading Port:
Qingdao
Payment Terms:
TT LC
Min Order Qty:
100 pcs pc
Supply Capability:
300000pcs Per Month pc/month
  • OKorder Service Pledge
  • Quality Product
  • Order Online Tracking
  • Timely Delivery
  • OKorder Financial Service
  • Credit Rating
  • Credit Services
  • Credit Purchasing

Add to My Favorites

Follow us:

Usage: Pipe Clamp
Material: steel、matel;Galvanized iron ,stainles
Band width:3mm/20mm
Connection:welding
Model number:As your requirement
Structure:Swivel clamp
Certificate:ISO9001:2008
Feature:
1.Use the open internal and external circle structure,and with screw fixed.It is effectively to solve the problem that when small diameter solft tube connect the hared tube,it is easy appear dead angle,and liquid or gas leakage problem.Easy structure,Easy maked.
2.Edge is no burrfree,it is ability to prevent the tube damaged
3.By a efficiently hydrogen relief treatment,long-term use needn't to worry fracture and other problems
Surface: zinc plated Packaging
4.Accord with DIN3017 Standard.By 48 hours salt and fog test,it has a good corrosion resistance
5.By our last 48 hours elastic test,to insure a high strength mechanical properties.
6.Easy to fix.
Working Temp: -40 ℃ ~ 110 ℃
Size:3/8" 1/2" 3/4" 1" 1 1/4" 1 1/2" 2" 2 1/2
Structure: Suspension Clamp and so on On-time shipment and pre-shipment product quality safeguards clamp is mainly used in automobiles,tractors, ships, gasoline engine, and so on each kind of mechanical
device for oil, gas, hydraulic hose connector, various types of
rubber tube interface must join parts fastening.
Detail: plywood case ,pallets or any other package as buyer's requirements
Delivery Detail: about 20-30days
Q:How does the 36V transformer change the starting power of the car?
With a 20 "2" tube, add a heat sink, just one end of the 2 pole to connect 24 volts one end, and then use a multimeter to measure positive and negative poles, and then connect it to the corresponding positive and negative poles of the battery
Q:How much power does a computer power 297W require?
Genuine 300W not 2 floor is a look at the white.At the very least, the 400W is rated and is slightly above grade!
Q:Why is the air compressor leakage gap will open?
Your fault may be indoor and outdoor connection line problems, the best method of inspection is to check the section to determine, otherwise you can check out the problem!
Q:Current detection small current
The detection of small current is usually measured in series with a ammeter. Alternating current is measured by an alternating current (AC) ammeter, and the direct current is measured with a DC (DC) ammeter,
Q:What is the cause of the tripping of the two phase motor?
Check the current with a clamp meter to see if it is overload. Measure the resistance of the two windings
Q:How can I measure the voltage and current with a clamp?
Using the method of measuring current clamp meter 1, before measuring clamp meter mechanical zero; 2, select the appropriate clamp meter range: from large to small range or see rating estimation; 3, when using the clamp meter minimum range measurement, the reading is not obvious, can be measured wire around a few turns the number of turns, turns to the jaw central subject is reading indication / full range X = partial x turns; 4, when measured, should make the measured conductor in the central and the jaw, jaw tight closing, in order to reduce the error; 5, after the measurement, to convert the clamp meter switch in the most in the range.
Q:Why do you use a multimeter to measure the zero line and ground wire?
The normal zero line with ground wire is not the zero line is tapped from the neutral point of transformer, wire from ground tap buried underground, but in actual use, line five wire three-phase voltage is 380 volts, the zero line and ground wire is not feasible, because there is a 220 volt single-phase equipment on the trip, will, 220 volts three-phase five wire circuit, because the zero line is rarely used, so the wiring, the zero line and ground line together.
Q:Current and power conversion of clamp type meter
Single phase 220V circuit, current, *220= power.
Q:A multimeter can measure AC current?
A lot of clamp meter with measured resistance, DC voltage and other functions, simple, ordinary multimeter on the function can do a multimeter. Many measuring DC current clamp meter with the function, but most are used, instead of using pen clamp ring.
Q:Would you please tell me how to use the DM6266 clamp type table with 261 insulation tester?
Measurement resistors are to be disassembled and measured and cannot be measured online; 266 of the resistance is measured at a higher voltage; and if compared to other digital meters, errors on line measurement are normal.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range

Send your message to us

This is not what you are looking for? Post Buying Request