Q:What's wrong with the gear ring slip?

1, driven by a motor starter gear to drive the flywheel, a clutch, suction and pull switch, belonging to the slip engaging device is broken, fight tooth squeaking and spark is pulling switch and drive gear or flywheel ring gear is bad of course for many reasons, the spark plug for oil, electric fuel supply, fuel supply system no, low temperature, low pressure etc..

Q:How is the thickness of the outer ring (outer diameter and internal diameter) determined?

According to the torque transmission size is different, it needs outside diameter and internal difference, the thickness is not the same

Q:PROE simulation, how to make the inner ring does not move, the planet wheel around the rotation

When assembling the first positioning ring gear, and then add the planetary wheel inside, inside the disc requirements and internal gear are coaxial, so that he can turn on the inside of the perforating hole disk, which can wear pins, pins should be installed outside the planet wheel, rotating.

Q:1115 how many teeth are used when the diesel engine is switched on?

If there are any problems in the above, please fix or replace it.

Q:How is the flywheel connected to the ring?

Storage of part of the energy in the engine's work stroke to overcome the resistance of other strokes and rotate the crankshaft evenly.

Q:The starting mode of a vehicle engine, in addition to the engagement of the cranking ring of the starter motor and flywheel, causes the crankshaft to start, what other starting methods are there? More details, thank you

2) the starting and starting device of the auxiliary gasoline engine is large in volume and complex in structure, so it is only used for the starting of large power diesel engines.

Q:The clearance between the slewing ring gear and the drive pinion

China rotary support trading network tells you that the slewing ring gear and drive pinion clearance, generally see if the modulus is consistent, whether the tooth surface contact reached more than 60 percentage points

Q:Ring gear material 50Mn heat treatment, conditioning is shrink or rise?

It also has something to do with the shape and size of the parts. It's better to do experiments.

Q:Where is the axle ring in the car?

Hello, ABS signal acquisition, generally on the outside of the cage, and I hope to help you

Q:How to deal with the bite gear of starter drive gear and flywheel ring gear?

Suggest replacing gears!2, the starter gear and flywheel teeth are loose, gear fixed position due to force displacement, resulting in tooth biting!It is recommended to be tested and fixed in detail!