Counter Balance Electric Stacker 1.2T

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Model


CDD14CDD16CDD16CDD12CDD12CDD14CDD16CDD16
Configuration No.  930 D930 950 030 970 920 D920 960

Power type

 Electric

Operator type

 Rider/ Walkie
Load capacity kgSee load strain diagram and mast configuration table
Load centre mm600
Wheel base mm   1325 1375 1270 11791325 1375
Standard mast lifting height mm   3000 3700 3000 25003000 3700
Overall width mm   850 937 812 1015   850 957
Ground clearance +fork thickness mm85   80 55 55 55

Service weight( with battery )

 kg 1270 1329 1612 11351830/1890 1280 1330 1606


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Can a forklift get on the highway?
Forklift is special vehicles, motor vehicles within the factory, the according to the regulation on administration of motor vehicle safety inside the plant, plant of motor vehicles, refers to an enterprise which is limited to within the scope of the factory (including production area such as docks, freight yard or construction site) and the operation of motor vehicles. So forklifts are not allowed to go on the road.
Q:What type of rubber forklift tyre
There are several tons of forklift trucks, and the wheels are on the side of the tyre. Diesel fuel car The front wheels of the 3.5 ton forklift are 28 times 9-15. The rear wheel is 650-10 The front wheels of the 3 ton forklift are 28 * 9-15. The rear wheel is 650-10 The front wheel of the 2.5 ton forklift is 700-12; The rear wheel is 600-9 The front wheel of the three-ton forklift is 700-12; The rear wheel is 600-9 The front wheel of the three-ton forklift is 650-10; The rear wheel is 500-8
Q:How to start a forklift? Say detailed point
Turn the key clockwise and start the engine; First notice the cargo fork: the control lever of the operating door is raised about 300 mm from the ground, and then the door frame is tilted forward to move. Step down the clutch control panel and move forward the back control lever and the gear stop. Slowly release the clutch pedal completely; Forbidding wild driving: don't turn on the key switch when stepping on the accelerator pedal. Do not suddenly start, brake or turn to prevent the fall of the cargo. Don't run over the barriers or obstacles that litter the road. Don't get into the soft ground; When driving on a wet, slippery, uneven or sloping road, please lower your driving speed. Make sure there is a gap between the door frame and the roof and the entrance.
Q:The forklift oil cylinder is leaking, and the newly replaced oil seal is no good
What is the piston seal?I hope my answer will help you
Q:What are some of the common failures of forklifts?
Forklifts cannot be started with the following conditions: 1, the battery without electricity Failure of starter The key switch is bad 4, the oil pump does not supply oil 5, there was no oil tank 6, no oil 7, the crankshaft lock The engine was completely scrapped
Q:Is this the electric forklift truck?
Logistics company if outdoor use can use more diesel forklift, may at any time come on, don't worry about the rain, the manual is ok, the operation is simple, automatic transmission dynamics. Battery forklifts need to be charged. But the electric bottle forklift truck is environmentally clean and less maintenance. In addition, the truck is loaded with a load of 1.5-3.0 T, requiring only diesel forklifts. The pure hand dozen, please accept.
Q:How does the forklift start?
Start the engine Step 1: step on the clutch pedal, start the engine, gradually increase the temperature of the engine, adjust the multi-way valve properly, and lift the fork lift off the ground about 15-20cm. (1) will shift in the middle (gap), hand brake in the braking state, insert the starting switch key and turn clockwise to "warm up" position, for 5 seconds, and then go to "start" position, at the same time gently on the accelerator pedal, and tread down the clutch pedal, starting time shall not exceed 10 seconds, once starting immediately after let go, the key to automatic reset, if the engine won't start, should lie between 1 to 2 minutes, starting again.
Q:Notice those items before the forklift
Before you start, look around and make sure that there is no obstacle to the safety of the car. (2) the braking pressure gauge reading must reach the specified value before it can start. (3) when the forklift truck starts, the driver should make sure that the cargo is stable and reliable. (4) start off slowly and smoothly.
Q:What is the section 4 and 3
The certificate of operation certificate and technical grade of forklift truck is issued by the bureau of quality and technical supervision, human resources and social security bureau.
Q:What is the difference between a forklift and a small 5t?
Five tons of solid and stable price is high, small five tons is flexible suitable for space small place to use

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range