Scrolling Led Message Board

Hot Products

FAQ

Led display point density is what it means
Is the number of units per area LED, pay attention to if the RGB tube is three, then only one
Ask to tell, or what decoder, mkv format can only put one, the rest of the mkv can not put any meaning?
a graphic editing, zoom, scroll, animation and other functions can display a variety of computer information, graphics, images and Two, three-dimensional computer animation, can be superimposed text ? broadcast system with multimedia software, you can flexibly enter and broadcast a variety of information ? a variety of Chinese fonts and fonts to choose from, but also enter the English, Spanish, French , German, Greek, Russian, Japanese and other languages ? There are a variety of ways to broadcast,
What is the difference between an LED display and an LCD monitor?
LED is Light Emitting Diode. LED applications can be divided into two categories: First, LED display; Second, LED single tube applications, including backlight LED, infrared LED and so on. Now on the LED display,
LED display more than the size of the area must be 380v
LED display itself only need low-voltage DC power supply, whether it is 380V or 220V need to go through the buck and rectifier, which is the screen does not matter. Whether it is to use 380V or 220V depends entirely on the load balance of the power grid considerations, which depends not only on the size of the display, but also on the local grid capacity. In general, LED is weak devices, even if the display area and then large, the total power is also less than where to go, so you can use 220V single-phase power supply, but the power supply cable cross-sectional area to be larger, but the power circuit Much simpler.
LED display a board dark light how is it?
What is the board? P10 There are three reasons for that. 1, first check the power on the line to the board on the line whether the soup or not connected! (Change line), 2, check the board above the terminal. (That is, to the board of the black plastic wire, a screw fixed line) that is and the board with welding wire welding. There may be no welding good. You can remove the outside kit. (Next to a small screw, unscrew on the line) to get a welding torch from the welding. 3, the original board on the Weld it Need to return to the factory new. The You said the board made dark may also be because the outside of the package drums appear perspective reflection. LED normal viewing angle is 70-110 degrees, the hope of the answer can help you
Led display brightness is not enough because of what are the reasons
If the screen is a very small piece of time is sometimes very dark, the unit is usually a problem, or drive IC problems, to replace. If the entire LED screen has become very dark, if the circuit board control system problems, it is recommended to restore the factory mode. If it is caused by the graphics driver, it is recommended to update or reinstall the driver.
Production of LED display the basic raw materials which ah?
PCB, circuit board, drive IC, resistance, exclusion, LED light-emitting diodes, row of pins, row seats, capacitors, three anti-paint, plastic sets of plastic, waterproof plastic, fine screws, copper pillars, magnets, Power cord, connector, switching power supply, frame. Control System.
Is the TV screen good for the LCD or the LCD?
In the television industry, LCD TV is divided into LED TV (depending on the backlight system) (using LED backlight module for the screen to provide light) and the traditional LCD TV (using CCFL cold cathode fluorescent tube light source).