Jepson Board Ceiling

Hot Products

FAQ

Gypsum board ceiling with gypsum-based ceilings
To 9.5mm gypsum board as the basic material material, by roller coating, pressure or paste PVC cover material, and made.
Gypsum board ceiling wood keel between the standard spacing how much
Home wood keel craft Home improvement commonly used wooden keel ceiling, the general process is this: 1, read the drawings, fully understand the drawing shape 2, the wooden side planing, brush on the fire retardant coating 3, on the wall pop-up ceiling horizontal line, and according to need, at the top of the first fixed a few longitudinal keel 4, the production of keel frame, the first on the ground first nail, shaped top application of blockboard model 5, The rod will be fixed wooden keel, and pay attention to adjust the level and vertical degree 6, set aside the lamp base or lamp slot position 7, by the electrician will be connected to the wire, and leave the thread 8, the cutting gypsum board with self-attack Nail fixed
How to install the ceiling on the gypsum board ceiling
According to the provisions of national norms, more than 3 kilograms of lamps, equipment must have their own independent boom, not allowed to be fixed in the ceiling or ceiling keel. Your ceiling lamp 15KG, ordinary light steel keel gypsum board ceiling simply can not afford such a lamp, you should put the lamp with steel bars to do through the gypsum board directly after the plaster board fixed to the roof of the structure, or the lamp can not be fixed Solid, more unreliable.
Construction of Common Gypsum Board Ceiling and Its Construction Technology
Family practice is usually two kinds of wood keel self-tapping screws fixed gypsum board. Require wood keel after fire treatment, single solid keel section is not less than 25 * 25mm. The keel is not less than 25 * 40mm. Screw fixing requirements can not break the paper, the screw from the edge of the board, the original edge of not less than 8mm cutting edge of not less than 12mm. Screw spacing of not more than 200mm. There is no cross seam at the seams of the gypsum board. Seam gap is not less than 1/2 plate thickness. Usually with 9mm gypsum board. Light steel keel requirements are basically the same. Just keel different. You ask the structure is not so clear that the need for illustrations, it is recommended that you find the standard Atlas. There will be double gypsum board on the practice. At the same time for large span ceiling need to be arch.
Is the gypsum line calculated by the perimeter of the house ceiling or by the total perimeter of the gypsum line?
According to the perimeter of the ceiling, after all, when the gypsum line in the use of cutting!
Home decoration to do the ceiling and cut off to use, I hope to recommend a good point of the brand, the most important is environmentally friendly and healthy, because there are small babies.
Remember to choose formaldehyde-free, gypsum board quality is good or bad depends on its strength, Jieke brand nominal than the national strength is 20% higher in the plate market, see Jieke gypsum board price from thirty More than eighty have, you can buy enough according to your needs, hope to be useful to you Oh
How much is the ceiling of the living room ceiling ceiling?
This specific depends on what material you ceiling There is a lot of use is a plaster carving this rich shape and the effect of comparison number can look to the building materials market The cost of their own decision
Gypsum board ceiling in the middle of a circular is how to get
You first use the nine floor plate made of 6 cm wide circle, after the overlap according to the required thickness of the two round with the wooden side, and then fixed with gypsum board veneer