Q:How to choose daylight lamp? What is the light bulb specification?

The fluorescent lamp shines after normal. Due to alternating current (ac) continuously through the ballast coil, the coil of self induction electromotive force, self inductance electromotive force blocking the current in the coil change, ballast step-down current-limiting role at this moment, the current is stable in the range of the rated current of the lamp tube on both ends of the voltage is stable within the rated voltage range. Because the voltage is lower than the ionization of the starter, so is no longer the starter in parallel at each end of the work, daylight lamp specifications: general search said 50 cm, 100 cm, 120 cm. Fluorescent lamp structure and function: each has a filament on both ends of the fluorescent lamp, inside the tubes filled with tiny amounts of argon and the thin mercury vapor, tube coated with phosphor, on the wall between the two filament gas when conducting an ultraviolet, the fluorescent powder soft light.

Q:LED T5 T8 and normal fluorescent lamps with no ballast

Say something practical, high brightness LED, energy saving, but there is light, if you are not willing to spend money to buy things, light failure will be very serious, fixtures are usually carry an umbrella the double tube is 20-30 yuan, tubes T5led18W market price has 40 - XXX, basically see the quality stand or fall, philips lamp wholesale is 5 yuan, fluorescent lamp with ballast, points electronic with inductance, the inductance of the durable, but noisy, electronic not durable but little noise, hand to hope to adopt

Q:Why does the led fluorescent tube have water vapour in it? What causes it?

The starter down. When the regenerator was knocked down, my home was my own scissors and cut off the ends of the two ends of the regenerator. Then attach the severed head to the insulation tape. search Put the base back to the original. The head of the LED fluorescent tube will be plugged into the base current

Q:The lighting is replaced by LED lights and circuit problems

My home is a branch. The whole thing is broken even the base is changed, the base is to take the shock drill to drill in the wall, my home has no impact electric drill. The part of the branch is just changing the daylight lamp. Save trouble. The first time I took the regenerator and the ballast down, I had a makeover. You just need to put the fluorescent tube directly on it. Very simple.

Q:Daylight lamp tube is broken, does not clean can be bad? In the office

Of course, it's easy to clean up the broken glass and then put it in a paper bag and throw it in the trash

Q:What about the normal daylight tubes replaced with LED tubes, ballast and flashers?

The rectifier and the regenerator can be removed, the specific installation method should be changed according to the electric way of the LED lamp tube

Q:Why is it that when my electric car is charged, the light bulb is burning in the house, and the incandescent lamp is fine, and the other appliances are normal

In your opinion. Is it just that it's ok if you don't charge? Or something? That's the problem if you charge it. Well, you'd better go and change the charger.

Q:How does the traditional daylight lamp tube replace the LED light tube?

The regenerator will be removed with the rectifier.I hope my answer is useful to you.

Q:What is the conversion between the number of leds and the number of tiles?

In this case, we'll talk about energy efficiency.I hope my answer is useful to you.

Q:I hope my answer will help you

It is recommended to remove the silver and then remove the lamp.