Q:LED how many protection levels does the underwater lamp have?

Protection grade of concrete, is the need to test the side can draw the conclusion that the common LED is divided into IP20, IP40, IP65, IP68, if LED underwater lights, at least to just above IP65, IP higher level of security, if the product quality is good, IP65 can meet the.

Q:How can the underwater lamp be buried in the pipeline?

General wiring pipe in waterproof below, reserve the position of the bottom lamp, throw the mouth, use high-grade rubber plastic cable wiring can

Q:How can I check the LED light?

To see whether compliance with safety standards, China's LED lamps safety standards have been introduced, please comply with the safety standards stipulated by the state to select LED lamps.

Q:See many companies do LED underwater lamp, underwater lamp is placed in the water inside it? Ask professionals in this area to resolve the specific uses of the bottom lamp

Large swimming pools, fountains, aquariums and other places for underwater lighting

Q:LED what's wrong with the underwater light?

The water lamp is too far from the transformerThis situation causes the voltage on both ends of the underwater lamp to be much smaller than 12V. Even if the light is good, the lamp will not turn on properly when the voltage is not reached.

Q:Installation method of underwater lamp and matters needing attention

As for other wiring, wiring joints do waterproof, general water electrician, decoration workers can basically deal with

Q:What are the components of the LED underwater light source?

Antistatic measures should be made. LED underwater lamp products to adopt certain anti-static measures, in the process of production and installation such as bench to ground, workers should wear anti-static clothing, anti-static ring belt, and belt of anti-static gloves, conditions can install electrostatic ion wind machine, but also to ensure the installation the air humidity is about 65%, in order to avoid the air is too dry to produce static electricity. In addition, different quality grades of LED anti-static ability is not the same, the quality of high grade LED underwater lamp antistatic ability better.

Q:What method of wiring underwater lamp will not enter the water to burn it?

I took submersible pumps, wires, underwater work for four years, so far normal. My method is to select the round cable as the power cord because the circle is well sealed. Wiring, put an end to the phenomenon of electric heating, use PVC waterproof adhesive tape tightly wrapped more than 10 laps, must tightly tie. Then I use geliahao glue, daub on the interface and the nearby, formed a new layer of insulating layer, must not be missed, and can be painted over several times. (if only PVC tape is used, water will still enter if the time is too long)

Q:What are the main parts of LED spotlights?

How to say it, hard to say, really, you grasp it yourself

Q:How to do waterproof treatment for underwater lamp joint?

Wire joint waterproof treatment should use special cable waterproof joint. The cable waterproof joint is a kind of connecting device which is often used in the electric power system.After the terminal is pressed well, the waterproof filling rubber is wound around the terminals, and the adhesive waterproof belt is used to strengthen the waterproof in the bad environment.