Q:LED lights string broken, how to repair?

LED lights string broken: you can check one by one, which is bad, which change.

Q:The number of lights in the LED string

In general, 1210 specifications of the band is 60 LED per meter, 5050 specifications of the band is 30 LED per meter, the special has 60 LED per meter.

Q:The top LED lights always burn the bulb in series

If the regulator is powered, it is necessary to lower the voltage

Q:Section LED lantern, no controller, can shine principleTwo now reduced brightness string string

Led 2 polar tube inside chip oscillator circuit, and the general appearance led 2 polar tube without distinction, only connected to the power supply of two kinds of color turns light, 1 seconds, I bought the 5MM red, blue autoflash. From the appearance of the series, but not necessarily in series

Q:Rated voltage of LED lamp string

LED is a light emitting diode. It can be used for AC and DC. Because of the reverse breakdown voltage of LED, it is very voltage. The single LED current can be connected by a ammeter to the inside. If you look at the rated current of LED, you should look at it

Q:Hanging on the tree string lights, each one is 10 meters long, with a controller, I asked the factory with the AB protection, but the manufacturers say that only do the general anti rain, no water, even the rain stop, I want to use plastic wrap, don't know? Which expert can give advice and advice? emergency

Now the market has launched a LED string lamp controller. Professional rainproof. You should be able to buy it at the big mall!!!

Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!

If it is a general common blue LED working current is 20 mA, voltage of about 2.5V can be lit, the battery power can be used in parallel, the benefits of this connection is one of the damage does not influence the normal operation of other LED. And each LED string to a current limiting resistor, LED protection lamp, prolong life, calculation formula of the resistance for V / 0.02A=: voltage current resistance: 3V, battery powered =3 / 0.02=150. You want to supply 55 LED batteries to work together, the total current is up to 0.02x55=1.1A, i.e. 1AH (ah) capacity of the battery can work 1 hours or so.

Q:How do you connect the LED lights?

Connect the bottom edge of the triangle symbol to the high voltage and the sharp angle to the low voltage. The bottom edge of the next LED is connected with a sharp angle

Q:Example: if I want to do a 40 head low voltage lamp string, do 10 lights, 1 loop, transformer is 150MA, then how can I calculate the resistance? The grid is 60 Hz of China's power grid! Give a formula, and then count the examples. What is it?! Thank you

In general, LED lamps need constant current to drive, and the voltage may be adjusted according to the aging degree of the LED lamp.

Q:Performance and characteristics of LED lamp string

The 1.LED light string is led by a light emitting diode packaged in an imported chip;The design of light angle 2.LED lamp string of the larger angle angle of >120 degrees, uniform mixed color, no color;3.LED lamp string selected LED dedicated constant voltage power supply mode, circuit design for constant current circuit, the work performance is very stable, so as to ensure normal life >5 hours;