♣ UL, CE, RoHS, REACH , 5510 .
♣ 10 years export experience.
♣ We are manufacturer.
♣ More than 15000 square meters factory.
♣ 127 workers and 12 engineers.
♣ Quality control system.
♣ Delivery On time.
Brass Cable Gland, Metal Cable gland,cable fitting,metal cable gland
Material: Nickel-plated brass
Temperature : -40°C~+100°, short-term to 120°C
Sealing: nitrile rubber
Protection degree : IP68-10Pa(tight point)
Cable Dia ring(mm)
Thread length GL(MM)
- Q:How to solve the computer connected to the TV audio problem, how to set the computer and TV audio separation
- In accordance with the relevant safety regulations, the power cable should not be parallel to the top of the thermal pipe laying, when can not be avoided, the interval distance should not be less than 1000mm, during which should also take effective insulation measures. Power cable and thermal pipe cross, the thermal pipe insulation layer, the separation distance should be not less than 500mm, no insulation layer should not be less than 1000mm, and in the cross with the insulation board to be protected, the length of the insulation board should not be less than d + 2000mm (d for the thermal pipe insulation layer diameter).
- Q:The difference between nylon balls and geese and ducks
- If the 2.5 square copper wire for the output extension cable, 20 meters distance, the total resistance of about 2 * 1.7 * 0.2 / 2.5 = 0.272 (ohms), the current maximum 1.8A, the voltage drop is 0.272 * 1.8 = ), The charging voltage is 55-0.5 = 54.5 (volts), a difference of about 1% will not have any impact on the battery. However, the third floor, said Ye Hao, you can put the charger put the debris room, from your house put a 220V power cord down, home and then engage in a switch control. It is best to design a light at home, can intuitively see if the electricity is full. That's better. Design light, teach you a way: to find a bad leakless protector, open there is a coil-like ring-shaped stuff, called zero sequence current transformer, it will be down, be careful, do not put Transformers inside the coil hurt, get down, in the transformer two thin lines connected to a light-emitting diode. And then your 220V power cord line of fire from the center of the sensor through, around 3-5 turns. In this way, as long as there is current flow, the light-emitting diode will be bright, when the charge is over, the charging current is close to zero, the light-emitting diode will be extinguished. You can from the light-emitting diode is lit to determine whether the electric has been filled. I also have an electric bike that is so charged.
- Q:1000 kW 600 m cable to use much
- Depends on the load is emotional, resistive, should be too long cable, consider the pressure drop. Generally consider 2.5 or more.
- Q:Apple 6 Charging Why always show this cable has not yet been certified
- 1 Definitions and basic tasks Communication lines and ancillary facilities Routine inspection operations are based on regional characteristics of regular light cable line inspection and protection line publicity, timely detection of problems, troubleshooting factors to ensure smooth communication; communication lines and ancillary equipment to make up Strong, to ensure that the optical cable lines and ancillary equipment integrity is good to prevent the occurrence of failure
- Q:Is the cable head made of every building?
- First, the cable production and installation of each building has. Second, the cable terminal set of waterproof, stress control, shielding, insulation in one, with good electrical and mechanical properties, in a variety of harsh environmental conditions for long-term use. With the advantages of light weight, easy installation and so on. Cable terminal is widely used in electric power, petrochemical, metallurgy, railway ports and construction and other fields. Third, the production process: including the following: . cut off the excess cable; . the cable protective layer of the stripping; . conductor connection; . wrapped around insulation (or shrink pipe); . install the connector shell; . ; . for sealing treatment.
- Q:7 kilowatts of electricity with what specifications of the wire
- 7 kilowatts of electricity with what specifications of the wire if it is single-phase 220V, then 7 kilowatts of current is 7000 × 220V = 31.8A, check the electrical manual 4 square copper wire interception is 33A, to meet the requirements.
- Q:What is the type of pipe that is marked as KBG pipe?
- Will the general power cable control cable can do the largest square...
- Q:25 square copper cable how much money one meter?
- 3 plus 1 64.13 yuan, 3 plus 2 75 yuan, 4 plus 1 81.38 yuan contact to see my registration name
- Q:Decoration doubt, what kind of wall can not open the horizontal groove?
- Power board problem cost 10 less than the general maintenance received you 150
- Q:How to distinguish how many pairs of cable with a large heat shrink tubing
- Yellow line is video, red and white are audio, you can only pick one!
It is a producer professionally engaged in wire protect-tube and cabling accessories. In the production process, we adhere to the standard of ISO9001 qualification system and domestic standard. According to ISO9001 qualification management system, our high-quality products won certifications of CE, ROSH, etc.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range