CONSTRUCTION:

Backing: polyethylene cloth (assorted colors)

Adhesive: Hot melt rubber adhesive

TYPICAL PHYSICAL PROPERTIES:

Total Thickness (adhesives + carrier): 200-220micron

Cloth mesh: 70

Initial Tack: ≥15# steel ball

Holding power: ≥2h

180°Peel Adhesion (to stainless steel): 16N/25mm

Tensile Strength: 40N/cm

Elongation: ≥20%

PACKING:

Core I.D.: 3” (76mm±1)

Jumbo Roll：1.06 x 500m/1000m

Packaging：Wrapped with corrugated cardboard.

Cut Roll: roll width 3mm up

REMARKS:

1.     The data above are typical results and subject to change without notice.

2.     Tolerance: Weight and Thickness: ±10%; Width: ±3mm;

Length: Cut Roll & Log Roll ±0.3m, Jumbo Roll ±0.5%.

3.     The products should be stored at room temperature and be kept away wet and/or heat source.

4.     It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, and free of grease and oil.

5.     The users should take test and do trial-application on the above products before coming into application so as to witness and ensure suitability for their special purpose and technique.