60kVA off Grid Inverter for Solar with Ce
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 pc
- Supply Capability:
- 8000 pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Description
Production Introduction:
This series inverter for double transformation power supply system.When the power grid appear outage, voltage instability, voltage interference, surge, peak and mains noise and other bad phenomenon, can guarantee the load working normally.
Application:
Widely used in electric power, communication, radio and television, banking, taxation and IT industry etc. To provide quality stable power for equipment load.
Working principle:
1. normal operation
Battery through the isolation diode to inverter power supply, and then by inverter transformation into stable alternating current (ac), Through static switch switch to EMI output filter for filtering, Finally on the output side also get a pure stable power supply to the load. From the inverter fault to the mains supply the entire process output no intermittent time. At the same time, the mains through another branch supply to charger after transformation to the battery charging. Showen as below:
2. Automatic bypass operation
When in the following situations inverter will automatically switch to bypass state power supply:
1)The front panel "ON/OFF" button switch without press the trigger boot, or after trigger not go by 20 seconds testing time delay.
2) Standby state
3) Inverter output overload or battery low voltage
4) inverter circuit built-in malfunction
When there is above circumstance, after the input mains through the filter, is no longer through the inverter switching, but directly to the static switch, after switch to the filter and then filter output. In the bypass state, mains also can charge for the battery.
Technical parameters
(1)Single into single out technical parameters
| 1KL~20KL(Single into single out model) technology parameter list | |||||||
| Model | 1KL | 2kL | 3KL | 6KL | 10KL | 15KL | 20KL |
| Rated capacity(KW) | 1KAV | 2KAV | 3KAV | 6KAV | 10KAV | 15KAV | 20KAV |
| Input voltage | Single phase two line + ground line, 220V±25% | ||||||
| Battery voltage | 48VDC | 96/192VDC | 192/240VDC | ||||
| noise | ≤52dB(Distance 1m) | ≤60dB(Distance 1m) | |||||
| size (W*D*Hmm) | 256×618×626 | 370×690×763 | |||||
| Weight(kg) | 30 | 40 | 45 | 60 | 105 | 130 | 160 |
(2) three into single out technical parameters
| RLD6KL~60KL(three into single out model) technology parameter list | ||||||||
| Model | 10KL | 15kL | 20KL | 30KL | 40KL | 50KL | 60KL | |
| Rated capacity(KW) | 10KAV | 15KAV | 20KAV | 30KAV | 40KAV | 50KAV | 60KAV | |
| Input voltage | three phase four line + ground line, 3800V±25% | |||||||
| Battery voltage | 384VDC | |||||||
| noise | ≤60dB(Distance 1m) | ≤65dB(Distance 1m) | ||||||
| size (W*D*Hmm) | 370×690×763 | 650×700×1600 | ||||||
| Weight(kg) | 165 | 190 | 210 | 400 | 450 | 530 | 620 | |
(3) Single into single out and three into single out general technical parameter
| Single into single out and three into single out general technical parameter | ||
| Input | frequency | 50Hz/60Hz±10% |
| Power factor | ≥80% | |
| Output | Voltage | 220V±1% |
| Voltage adjustment | Regulated±1%,dynamic±2%,(0-100% load change < 20 ms) | |
| Frequency stability | 50Hz/60Hz±0.5%(battery powered) | |
| Frequency torsional rate | Less than 1 hz/sec. | |
| Harmonic distortion | Linear load is less than 3% (load), rectifier total harmonic is less than 5% | |
| Overload capacity | 130% | |
| waveform | Wave form | |
| efficiency | Input AC to output AC | More than 95% |
| transfer time | Transfer between mains and battery | 0 seconds |
| Transfer between inverter and bypass | Less than 4 millisecond | |
| battery | type | Lead-acid seal free maintenance |
| Charging time | After completely discharge 8 hours and charged to 90% | |
| Alarm song | Overload load | Output overload, tweet once every 1 second |
| Output severe overload protection, continuous tweets | ||
| Battery discharge | Mains power supply failure, tweet once every 4 seconds | |
| Battery low voltage beep once every 1 second | ||
| The battery discharge will stop, continuous chirping | ||
| Fault anomaly | continuous chirping | |
| Protection performance | battery | Battery low energy automatic to jump to BYPASS,after the battery saturation automatically recovery |
| overload | Overload (120 ~ 150%) 30 seconds later automatic to jump to BYPASS, automatic recovery | |
| Over temperature | Inverter internal temperature > 85 ºC, automatic to jump to BYPASS | |
| Output short circuit | The current limit and automatic shutdown, fuse and no fuse switch protection | |
| Inverter anomaly | Automatic to jump to BYPASS and the mains supply | |
| LCD display | LCD display information | Display input and output voltage, frequency, battery voltage, output load |
| environment | temperature | -10~50ºC( |
| Relative humidity | 20% to 93% (non-condensing) | |
| altitude | Altitude 1000m or less | |
Warranty:
Quality warranty for 1 year; parts will be shipped free during warranty period.
Delivery time:
Stick to contract.
- Q: Solar products must be in the sun
- Other light sources can be used to meet the needs of the product (e.g., solar watches can be recharged by other light sources)
- Q: Product category and comparison of solar thermal utilization
- The solar industry did a survey on the overall evaluation of the use of solar energy users, think very satisfied with only 3.5% basic satisfaction was 12.6%, average and unsatisfactory accounted for 35.2% and 48.7%; the user evaluation of the service, satisfied and satisfied for a total of 24%, and that no service dissatisfaction accounted for 76%.
- Q: Solar electric vehicle charging device
- Electric vehicle solar energy products are small in size, light in weight, easy to install and carry. Is a domestic initiative, has applied for national patent. Market potential is very large, very broad prospects.
- Q: Is it hot in summer and the water is hot in winter?
- Wall type solar water heater can belong to the separated type solar hot water system, water tank placed in the balcony or exterior wall, the collector is placed at the south facade of building a balcony wall hanging type solar water heater with flat collector to absorb solar radiation into heat, heat to reach the water tank and the water heat exchanger, so that the temperature of the whole the water tank is increased gradually, let the user can enjoy free hot water from the sun.The successful use of plate heat exchanger technology in wall mounted solar products, not only improves the thermal efficiency of balcony wall products, and the successful implementation of the building safety products and life integration, so that the water heater installation expanded to all floors and is not limited to the roof, and greatly lifted the traditional solar water heater, frozen fried tube, easy Water Leakage, easy scaling problems.
- Q: How to make better use of solar energy
- The history of modern solar energy can be calculated from the 1615 French engineer Solomon de Cox in the world invented the first solar powered engine. The invention relates to a machine for pumping water by using solar energy to heat air to make it work. Between 1615 and 1900, the world has developed a number of solar power devices and other solar devices. Almost all of these power plants by condensing method to collect the sunlight, engine power is not the working fluid is mainly water vapor, the price is expensive, little practical value, for the majority of fans of solar energy manufacturing. Twentieth Century 100 years, the history of the development of solar energy technology can be divided into seven stages.
- Q: How to do a good job of solar water heater marketing?
- Two, energy saving (cost savings): the impact of solar water heater life components. About the use of solar water heaters for heating homes, can save daily for heating water electricity, gas costs 90%, can reduce household expenses, to the society, can reduce our province limited energy resources consumption, the energy and ancillary facilities for agricultural and industrial production, have greater social benefits.
- Q: Or must there be built - in battery? If yes, then use the mobile phone lithium battery can?
- Solar panels can not be used directly to charge mobile phones and other products. The output voltage of the charger for mobile phone and other products at around 5V, and the output voltage of the solar panel is not fixed, fluctuated, when more than 5.5V or higher, causing permanent damage to products such as mobile phone, must control the output voltage between 4.5 ~ 5.5V through the conversion circuit.Built in battery is in order to output more stable, but the premise must be configured safe and effective protection circuit and voltage conversion circuit.
- Q: What are the functions of the new vehicle negative ion solar charging humidifier?
- Brown vehicle negative ion solar charging humidifier, in addition to negative ions and solar charging function, but also can be used as car fragrance, you can add essential oils.
- Q: Good solar polymer or monocrystalline
- Many of my friends would ask is good or good crystal crystal, we many people buy just as ordinary lighting and small system to watch TV, to tell the truth this is really no need to care about the single crystal or polycrystalline, regardless of the need is a power is enough, two is the price is good!The difference between polycrystalline and single crystal: single crystal plate is black, polycrystalline plate is blue or color.Disadvantages: the same power of the single crystal plate with polycrystalline plate, polycrystalline board area slightly larger than the area of single crystal board, the same as the 50W polycrystalline will be 1.1 times larger than the single crystalThe utility model has the advantages that the polycrystalline plate is a plurality of directions to receive light and has good directivity. The actual test, hypothesis with one hand to block the sun's rays to solar power on the surface of a shadow, so many crystal board power current decrease is not obvious, but the single plate power current is reduced obviously, this is the advantage of multi crystal plate.
- Q: The steps of making solar technology stubs
- Making method:1 at the end of the rubber to dig a shallow small round hole 2 to remove the brush pen head, clean and dry.3 cut the tip of the brush head into a small brush4 put the brush head into the small hole in the rubber, glue (complete)2 small production: solar hot water bag
Send your message to us
60kVA off Grid Inverter for Solar with Ce
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 pc
- Supply Capability:
- 8000 pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
