white plastic can motor running capacitors

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Case:Round plastic case,quick connector terminals,anti moisture,anti explosion,good self-healing,good insulation etc.

AC film capacitors for general purpose applications (e.g. AC filters with harmonic frequencies exceeding 60 Hz), as well as for lighting and motor run applications.For the latter, AC capacitors are used in conjunction with asynchronous motors on single-phase mains supplies. They are designed for 50 or 60 Hz systems.


Applications:Asynchronous motors、Air conditioning、Domestic appliances、Compressors/pumps/garage、door openers、 Awning drives、 Heat pumps etc.



****Specifications****
Standard temperature
-40℃ ~ +85℃
Voltages Ratings
250V ~ 500V AC
Capacitance Range
1~60 uF
Applicable Standard
IEC60252-1:2011,GB/T3667.1-2005.UL810、EN60252-2:2011
Size


D±1mm
30
35
40
45
H±2mm
60-80
60-80
60-90
70-100


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:What is the phase-shifting capacitor, what is the difference between it and the general capacitor
And the phase-shifting capacitor has the function of changing the phase of the alternating current signal in addition to the characteristics of the general capacitor. The answer can be compensated by the power factor compensation in parallel with the phase-shifting capacitor, and the phase-shifting capacitor can be used to produce the phase-shifting capacitor fault diagnosis device.
Q:What is the relationship between capacitance and voltage?
The larger the capacity of the capacitor, the larger the voltage, the smaller the capacity (uF). Since q = Cu, q is the current charge number of the capacitor, which is substantially proportional to the volume of the capacitor
Q:Capacitance for AC and DC effects?
Current waveform ahead of the voltage 90 degrees, in a sine wave cycle, half of the time ( Voltage waveform 0-90 degrees and 180-270 degrees) power to charge the capacitor, while the other half of the time (voltage waveform 90-180 degrees and 270-0 degrees) capacitance of the power discharge, the power and intact return power The
Q:Capacitance can pass high frequency resistance low frequency principle
The capacitor has a charge and discharge time problem. When the positive half of the AC, to the capacitor charging moment, the circuit is a current flow, the equivalent of the channel, once the capacitor is charged, the circuit will not flow through, the equivalent of open circuit.
Q:Use capacitance to do transformer how to calculate
Capacitance buck method: For example, we will be a 110V / 8W bulb and a 1uF capacitor in series, received 220V / 50Hz AC voltage, the light bulb is lit, the normal brightness will not be burned. Since the 110V / 8W bulb requires a current of 8W / 110V = 72mA, it is consistent with the current limiting characteristics of the 1uF capacitor.
Q:How to judge the capacitor is good or bad?
Due to the amplification of the composite transistor, the measured capacitance of the charge and discharge process to be amplified, so that the multimeter pointer increase the amplitude, so easy to observe. It should be noted that: in the test operation, especially in the measurement of small capacity capacitance, it is necessary to repeatedly change the measured capacitance of the pin contact A, B two points, in order to clearly see the multimeter pointer swing.
Q:What is the principle of capacitance isolation?
The structure of the capacitor is two plates, separated by a layer of insulator, so under normal circumstances the capacitor is no current through (unless the middle of the insulation was breakdown).
Q:How does the capacitor work? What does it do?
Capacitance works: the principle of charge and discharge simply put the capacitor is the two poles charged or discharge, that is, charge diffusion. Charge and discharge capacitors should be connected in series, can be connected in parallel; it is the basis of other properties of capacitance. The phenomenon of intermittent communication is the embodiment of charge and discharge, if it is DC, charged to stop, the capacitor charged; if it is alternating current, is constantly charging discharge. Complete the transmission of AC.
Q:What is the difference between the reactor and the capacitor?
Reactor is the inductive load, there are series and parallel in series, the series is mainly used to limit the short-circuit current, parallel mainly used for ultra-high voltage long-distance transmission, the compensation line capacitance. Capacitors are capacitive loads that are used primarily to compensate for reactive and energy storage. Inductance and capacitance combinations for filtering and so on.
Q:Why does the circuit current gradually decrease when charging the capacitor?
Why does the circuit current gradually decrease when charging the capacitor? Because the charge began to charge the capacitor, the capacitor two electrode plate charge began to zero, the electrostatic field is zero, the absorption of electrons is not exclusion, the performance of the phenomenon is the beginning of the charge when the circuit current is very large, with the capacitor The charging time increases, there will be more and more charge adsorption on the capacitor two electrode plates,

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range