Lift Rated Capacity
Platform Extend Capacity
Wind speed 45km/h
Max. Machine Height
Max. Platform Height
Platform Extend Length
Hydraulic oil box
-Can bus line intelligent controller
-Automatic pot hole protection system
-Electric circuit fault code display
-Rotary strobe light
-Euro Ⅲ emission standard engine
-Hydraulic electric welding machine
-Hydraulic air compressor
-Hydraulic high pressure water pump
-Hydraulic oil radiator
-AC power source connected to platform
The product is mainly applied in the fixing, constructing, detecting and maintenance of large-scale bridge, steel structure workshop and sorts of aerial equipment. It can be used in all kinds of rugged terrain. CE certified.
1)Structure: scissors, enable extended-platform, good performance of elevating and loading.
2)Sole control system, drive mode: 4×4, maximum speed：6.5km/h.
4)Tilt alarm, the auto-leveling system of four crutch-leg .
5)Emergency down-valve device.
6)Double anti-press protection: electric-control and safety-web.
- Q:How does the table in the middle of the tatami mat go up and down
- Opposite position: put the platform and the table board into the central pit of the tatami mat. Drop the lower part of the platform to the bottom, make the table and the tatami mat surface level, and adjust the horizontal position to make the gap between the table and the table evenly.
- Q:The characteristics of hydraulic platform
- Light weight, good maneuverability, suitable for individual operation. The special mast strap-step device, which is smoothly and smoothly; 3, compact structure, small size of transportation, can enter the car of general elevator and pass through the door and narrow passageway. Double protected leg structure, work safer, and can be close to the working face lift.
- Q:Does the fixed hydraulic platform need to submit to the specification requirement
- There is no clear regulation of hydraulic lift and hydraulic platform in China, which means that you can also do it without testing. Local regulations may be different. Also, if you check, you are going to the local quality and technical supervision bureau. Should go to the special branch to register, apply for installation, after installation is finished again ask them to check the acceptance of the check. There is a fee for it. And it will be checked every year.
- Q:Diy a small platform principle
- If use reduction motor may speed not soon (and consider the design of lifting platform under actual gravity reduction ratio), the situation of the specific need according to the design requirements, weigh the pros and cons.
- Q:Diablo ii flame volcanic mission will not be able to jump
- Instead of letting you jump on the platform, let you jump across the plank on the side wall of the platform, which is used upstairs. Just go to the opposite side.
- Q:Description of fixed hydraulic elevator
- Main USES: installation maintenance, such as power line, lighting, elevated pipe, etc. Applies to can't work of the excavation pit, USES the chain wheel lift height, with a single break, double break, adopt effective guidance system, make the lifting platform in the process of translation and small gap with fixed bed, smooth operation, stepless speed change. The synchronizing device adopts low speed large torsional drive, which can be completely parallel, freely and retractable in the lifting process. The machine is stable and safe, suitable for the supermarket, hospital, restaurant, shop and so on.
- Q:The characteristic of shear fork platform
- The fixed platform shall be equipped with the requirements of use, and the attached devices shall be configured for any combination such as the safety protection device of the platform.
- Q:The home is decorated, make a tatami mat the platform should pay attention to what aspect?
- The second is to notice whether the product has a secure clamping system. Most of the products on the market are mechanical clamping system, which is low in safety, and the system is too resistant to it. Best choice is the electronic control system, because it will through the electronic system induction to the resistance changes, more than a certain value will stall, electric and automatic recovery (electronic resistance setting values are very sensitive, high security), such as task of children. The third is, of course, the manufacturer and the brand, the good manufacturer and the brand make the product more reliable, which is not to be said in detail.
- Q:When the hydraulic platform drops, it feels very shaken and unbalanced. Please answer?
- Connected to the solenoid valve is the control valve core, if it is to be repaired. To change oil, you need to lift it up to the top, and then use the safety support frame or stick to support it so that you can do what you want
- Q:The ball of the universal milling and lifting platform rolls off, how to install,
- Screw has a variety of forms, one of the most common is to use return and return two catheters, if not nut screw the screw will not drop the ball, if there is no turn the screw nut and fell out of the ball, that is to return or return pipe is broken, have to put on reload. Let me be specific. If there is no damage, then use the lithium base grease to keep the ball rolling in separate loops, and then turn the nut back in the way of the regular nut. The key is to start at the beginning, but once the ball comes out, it's going to come back again. Try it twice. (note the non-circular path (snails) don't let the ball drop!)
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range