Q:Technical requirements for LED street lamps

Market street lamp lens material for the improvement of optical materials, transmittance is more than 93%, high temperature -38 +90, anti ultraviolet UV ` etiolating rate for 30000 hours without change.3.LED street, the main lens for LED street lamp, spot is rectangular, the material is PMMA optical material, transmittance is more than 93%, high temperature -38 +90, anti UV UV ` etiolating rate for 30000 hours without change,

Q:Can the power supply for the LED street lamp be placed under the lamppost?

In fact, it is more convenient to put the driver into the electric door directly. If the later stage needs maintenance, it is not necessary to remove the whole lamp.

Q:How to determine the power of LED street light?

Because this situation does not see the chip surface, so it can only be estimated(attention: eundong Street)Supplement:LED street lamp power LED street lamp power and rural branch city road has no clear standard, but in general: LED lamp power city road about 80W-250W LED Street Village Branch power about 30W120W.

Q:What's the reason for the flash of LED street lights?

1, should be the power line diameter is small, the power one start, the back voltage is low, so the street lights flash2, the other 18 pull a pair of power lines.3, the front 18 lights closed, leaving only the back 18 can be confirmed.4, the first 18 and the latter 18 do not start at the same time.

Q:What are the prospects for the development of intelligent LED street lamps?

Before 2015, LED Street will remain around 50% compound annual growth rate, by 2015, LED road lighting lamps in the field (mainly for street lights and tunnel lamp) the overall penetration rate reached 46%, the next two years will add more than 30 million LED street lights and tunnel lamp. These favorable expectations have brought greater potential for development of LED street lamps.

Q:What is the distance between the usual street lights?

There is no standard, and some are required to achieve the value of illumination, there is no hard and fast requirements, generally speaking, the distance between the street lamp and the lamp height and the number of watts.

Q:What are the standards for LED street lighting?

Light efficiency, the good light theory is 100lm/W, 100 watt incandescent lamp is about 1200lm, that is to say, about 12W LED lamp luminous flux is equivalent to a 100 watt incandescent lamp, this is the origin of energy saving. Of course, in fact only theory, but also the specific consideration of power loss of LED, loss and attenuation of photothermal divergence, and so on, is not to say, here is not to write.

Q:How to calculate the number of Duodawa with LED lights

First of all, if the width of the road is 20 meters wide, the road should be the main road, and the cloth lights will do.Assuming the double symmetrical cloth light, the lamp pole height is at least greater than the width of the road 1/2, so the pole height is 12-14 meters.Suppose the 14 meter pole, the street lamp installation spacing is generally about 3 times the height of the lamp post, so the distance is at least 40 meters.40 meters distance, height 14 meters, in this case, LED street lamp power to more than 200W power, can basically meet the main road lighting requirements.

Q:Does LED street lights save electricity?

But if using white light LED for lighting, not only light efficiency, and long life (continuous work time of more than 10000 hours), almost no maintenance. At present, the German company Hella LED developed using white light aircraft reading a street lamp; the Australian capital Canberra has used the white LED lighting lamp; city traffic management in China is also white LED to replace the early order of traffic lights. It is foreseeable that in the near future, white light LED will enter the family to replace the existing lighting. LED light source with the use of low-voltage power supply, low energy consumption, strong applicability, high stability, fast response time, no pollution to environment, color light etc., although the price is compared with the existing lighting equipment is expensive, it will inevitably replace the existing lighting device.

Q:What are the parts of a LED street lamp?

The working principle and design of solar street lamp LED 2008 01 Friday 25 March 22:28 with the world energy crisis intensifies, countries are seeking a solution to the energy crisis, a road is used for new and renewable sources of energy; the other one is looking for new energy-saving technologies, reduce energy consumption, improve the utilization efficiency energy.