IP66 LED module full color 3 SMD-LED with lens
Lens Make 20% Brighter, and reducing overal system costs
2835 SMD LED / 3 LED MODULE
Lens make 160 Degree
60(single led module)
0.72W(single led module)
Quick Selection Guide: LED Injection Module For Channel Letter
Depth of channel letter(mm)
1. The test results are based on 3mm thickness white acrylic panel and 6500K led module
2. Blue line is best product performance at Max LED pitch
- Q:How does the LED light string flash?
- LED because of its special structure, frequent startup does not reduce its service life, but high temperature can significantly shorten its life. So cooling is important for LED.
- Q:Rated voltage of LED lamp string
- You are the light string and see how much you a lamp, the lamp voltage for LED in 3.0-3.4V, for intermediate values of 3.2V, N=220/3.2=68.75 so many beads. In fact, we are in terms of LED is a DC device, there is no voltage rating, mainly to see his current value, the work must be steady flow. The power 0.06W LED current is 20MA, the power 0.2W LED current is 60MA, the power is 0.3W, the LED current is 100MA, the power is 1W, the high power LED current is 300-350MA, and so on in turn, ah, I=P/U
- Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!
- You can use the 4~6V battery, through the 4W, 2~3 Europe (6V with 3 Euro, 4V with 2 Euro) current limiting resistor, to the LED lamp power supply. The parameters of each lamp are: 3V, 20MA, in parallel (polarity). If you don't quite understand, you can also ask a science and engineering student (preferably a teacher) to help.
- Q:How do you connect the LED lights?
- LED lamp can string together end to end, with more than 24 fluorescent lamp series, bulb lamp with 5X1W5 lamp series, and 6 series and 14.
- Q:What is the principle of the LED series?
- When electrons and holes are combined, they can radiate visible light, so they can be used to make light-emitting diodes. In circuits and instruments, as an indicator, or in combination with text or digital display. GaAs diodes glow diode gap, green silicon carbide, yellow light diode, light emitting diode gan. Because of the chemical properties and organic light-emitting diode OLED and inorganic light-emitting diode LED.
- Q:What's the average luminous current of an ordinary LED lamp string?
- General LED patch to 0.2W, 0.5W, 0.2W lamp current is 60mA, 0.5W beads 150mA,
- Q:The top LED lights always burn the bulb in series
- If the regulator is powered, it is necessary to lower the voltage
- Q:Low voltage LED lamp string resistance is how to count, there is no formula?
- Diode products cannot be calculated by resistors.
- Q:Who knows how the controller of outdoor LED lights can be protected against water?
- You can use the plastic wrap, mouth down, so even if again under the rain is not bad. Or glue the entire controller to the point where the water is likely to enter the water.
- Q:Led full-color light string and how to control wiring
- Three line full color exposure lamp data signal two, the controller needs two wire negative electrode control, GND signal connected to the DAT surface
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range