surface shower brass thermostatic faucet
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100 set
- Supply Capability:
- 10000 set/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1:38℃ SECURE stop: Button for blocking the temperature at 38 ℃
2:EASY system: One mono - block internal cartridge, which you can take out
and put back in a matter of seconds.
3:ECO-stop: ECO-stop function limits water flow, with a savings of up to 45%.
4:38℃ACCURATE control: More accurate, stronger, and more resistant.
Guarantees greater safety maintaining the water temperature constant with
more accuracy.
5:FAST reaction: Very fast reaction time and temperature balance
6:WATER saving: Going from cold to hot uses up energy. Making this process
quicker means using up less.
Technical reference:
Material | Brass main body and zinc alloy handle |
Material Analysis | Cu≥ 59% |
The Thickness of chrome plating | Nickel>8um Chrome>0.2um |
Water flow | Bath/shower mixer ≥ 18L/min |
Operating pressure | 0.05Mpa-0.8Mpa |
Recommend pressure | 0.1Mpa-0.5Mpa if>0.5Mpa Installation of a flow reducer is recommended |
Cold water temperature | 4℃-29℃ |
Hot water temperature | 50℃-80℃ |
Temperature range | 20℃-50℃ |
Security stop | 38℃ |
Cold water supply failure test | Within 5 seconds after cold water supply fails, outflow rate automatically drops to 1.9L/Min, outflow quantity:≤150ml |
Life test | CSA B125-98 ASSE 1016(=100,000 cycles) |
Outflow temperature Auto-adjusting sensitivity | When inlet water temperature or pressure varies, outlet water temperature change will be less than ±2℃ |
Standard Apply | CSA B125-98 ASSE 1016 EN1111 AS-4032.1 EN817, ACS, WRAS, ISO9001 |
Quality Guarantee | 5 Year quality guarantee |
- Q:Kitchen faucet always close tight, leaking, what is the reason?
- The problem is too general, may be the water dragon Geng Ji Li Li Dian Dian for the head of the problem. Inside my ball is broken. New ones It may also be a leak in the faucet and pipe interface. Remove and add the raw tape and tighten again. The other did not see do not know.
- Q:Kitchen hot and cold water faucet, how to repair? The faucet can be rotated 360. Handle and spool I can remove it. The leaking part is the faucet and the gap of his last section. How to remove the faucet faucet quincy arrogant horny buddy ketone? Question added: 360-degree rotation that section below the base is difficult to screw down, what tips? More
- The lower base can be screwed down
- Q:Will the normal household kitchen faucet, 24 hours uninterrupted water, 10 days to let go of the number of tons of water. Because the New Year that year out of New Year. , The home water, the kitchen faucet in the open state, then do not know whether to close. It was not until the morning that the water was found. Distressed ah, would like to ask who knows how much I wasted Shan Fenhuang torr good fork in the number of tons of water. Thank you. More
- Depends on the size of your water pressure can be calculated, the general flow of 10 liters per minute.
- Q:My home gas water heater, the kitchen of the faucet normal burning II OKorder Gui snapped with the Dan anchor hot water, but the shower hot water faucet no hot water, gas water heater just started running, but it is not burning, out of the cold water? The Why is this? More
- May be a small water pressure, you can adjust the water heater II seductive seductive nail with Dan anchor water volume to adjust the point, if not, there may be a shower hot water faucet and shower at the plug, need to remove the inspection.
- Q:How to handle the faucet handle at home?
- These two faucet handles can be replaced.
- Q:How the kitchen faucet is broken
- Faucet internal structure failure can not repair, buy a new one can change "turn off the tap water"
- Q:My kitchen with a gooseneck hot and cold two-way faucet, because there is no water heater installed, so the hot and cold water interface did not take the tube, but now, open to a direction, but never take the taps of the other exports of children Ephheng water, flow of a place, almost soaked something, consult a master, how is this? Welcome advice: Question added: Hello, first of all thank you for your attention to the news. This is the kitchen with the gooseneck two-way faucet, you can access cold water and hot water, because the water heater is not installed, so the faucet of an interface is not connected, only took a mouth, some time ago is good, but yesterday I found When I put the faucet handle to the cold side of the water when the other end of the tube did not take the other end of the water, and the water is not small, a lot of flow, do not know you can understand no, thank you faucet String of water Show the faucet bad? Repair, or re-buy a way? More
- Not specifically understand that the workers may be negligent, the hot and cold water will be wrong, the child drink powder and so on. The workers re-take the leading hose on the line.
- Q:The water of my family's kitchen is very large and is now small. The switch seems to be the same. Other such as the bathroom faucet on nothing, the water is great. What are the reasons for that? More
- There may be something inside the plug is blocked as long as the faucet outlet unscrew clean up on the OK
- Q:Home kitchen faucet flow is particularly small, a few days ago I put inside that small network pull down, but still not. Which seems to have a white plastic stuff, is not the filter to install the shield shield torch moxibustion fall mismatched lack of wiping it? Do not know how to do it? Who has a good suggestion? Thank you! The More
- Faucet in front of the mouth with a wrench can be screwed down, you pull the net from the outside do not pull down, inside the white plastic thing called foam, is to prevent the water splashing around. The water is small it is blocked by impurities, screw down to clean the impurities just fine. Unscrew the installation without the need for raw tape, itself has a gasket
- Q:Single handle double pipe faucet, handle twist too tight, want to open to get it, the results can not find the place to be demolished. Seek professional advice. Question added: I find a circle, did not find what the so-called nuts, no hot and cold water signs, continue to seek answers. Note that I was going to tear the faucet, not to remove the faucet. Han often end of the end of the full number of phoenix
- It is not the handle. The root handle can be screwed down
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
surface shower brass thermostatic faucet
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100 set
- Supply Capability:
- 10000 set/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Related keywords