Q:How to use the ball screw platform?

Second, heyman screw can see lu, platform settled on first use, carefully to see if there are any more abnormal hydraulic parts, electrical appliances, layout, to ensure that no more than about geomagnetic held before commissioning, no-load again after 3 ~ 5 times a load test.

Q:The advantages and disadvantages of using diesel engine as an engine

Polluted air, the exhaust fumes from diesel engines are not processed directly into the atmosphere, making environmental damage more serious. Make noise, noise pollution has become another environmental pollution, the diesel engine will obviously affect people's work and life when working. (3) at low temperature is not easy to start, when the environment temperature is lower than 5 ℃, the machine, diesel brand is undeserved, cause machine, diesel oil viscosity is bigger, the diesel engine crankshaft starting resistance moment is larger, it is difficult to start, affect the normal operation.

Q:There is no elevator on the 7th floor of the home to install a lift or lift

What do you want to do? Can you agree to install these things? These later additions can only be set outside the building, affecting the fire channel.

Q:How to maintain the platform?

Remove the hydraulic oil and remove the oil strainer, remove the oil strainer, clean it up, and then put it back in the tank and connect the pipe. (put on new oil and don't use the old oil. Otherwise, the moving parts of the hydraulic lift system will accelerate the wear and tear.) Remove and disconnect the lift valve, blow the plunger down with compressed air, then load and resettle. Check all hydraulic pipes and connectors. The pipe should not be broken, the joints should not be loose, and all the joints must be tightened.

Q:What can be done when the hydraulic platform is down?

Your reason is simple: the oil always goes to the small oil tank, causing the load to be light first, and the cylinder is out of sync. The solution in the economy is to buy a synchronous shunt valve for the oil supply of two cylinders. In the transfer valve A or B, one is solved

Q:Is the music console working? Want to start a, afraid to buy expensive again.

It belongs to the table at the table, which means you can use it when you remove it and put it on the table.

Q:What standard elevator platform needs to go to the special equipment inspection to report

Hoisting machinery, it is to point to used for vertical lifting or vertical and horizontal moving heavy mechanical and electrical equipment, its range is rated lifting weight greater than or equal to 0.5 t elevator; The weight is greater than or equal to 1t, and the lifting height is greater than or equal to 2m crane and weight bearing form fixed electric gourd

Q:The structure of the universal elevator milling machine

The main shaft is used to install the tool pole and rotate the milling cutter. The main shaft is a hollow shaft with a 7:24 precision taper hole in the front, which is used to install the taper shank of the milling cutter. The longitudinal platform is carried by longitudinal screw, which is carried on the guide track of the turntable, and the workpiece on the surface of the table is moved vertically. The T groove on the surface of the table is used to install the fixture or workpiece.

Q:What happened to the rise and fall

The first possible reason is that the voltage is too low to check the actuator potential of the motor load. For users, a huge lift seems very mysterious, from which a small parts out of the question can let you helpless, Beijing force high lifting mechanical wang manager here to give you a little small pupil:

Q:What about the heat treatment of the lifting platform?

Servo feed system stability is the most basic condition to work, especially when low speed feed does not produce "crawl", and can adapt to the change of the external loads and does not produce resonance. Stability is related to system inertia, rigidity, damping and gain. The life of the feed system, is mainly refers to keep the transmission accuracy of nc machine tools and positioning accuracy of the length of time, namely the transmission parts's ability to maintain its original manufacturing precision, therefore, should be a reasonable choice material, heat treatment and machining process to the transmission parts, and adopt suitable lubrication method and protective measures, to prolong life.