Q:Can the stepping motor drive the hydraulic platform?

The hydraulic platform is driven by an oil cylinder, and the motor drive is a completely different way through mechanical means (screw, chain, gear, rack, etc.). In addition to mechanical means, depending on the power size, the step motor usually means that the equivalent power is not much, the maximum is a few hundred watts. The hydraulic platform is generally heavy, so it's unlikely. Or do you use a step motor to drive the hydraulic pump? It can, but also to consider the power problem, said earlier, smaller power stepping motor, if the original motor is a few kilowatts, certainly not.

Q:How does a button in the PLC control the elevating platform

Click on the rise to the top, and then the bottom? This can be used to refer to a button that controls an electric motor The elevating platform must have the upper and lower limit, and can not stop in the middle. Not safe.

Q:Is the elevator moving faster or slower?

Speed of computing: lifting speed is equal to the lifting height/(the volume of a cylinder/pump displacement) this article provided by jinan international hydraulic machinery co., LTD. Is for reference only

Q:What device is better to design a platform that is 1 square meter or so?

Elevating elevator, lifting platform, four-wheel mobile elevator, aluminium alloy lift, fixed lift, rail lift, truck lift

Q:You need to make a small lift platform, on top of the robot, non-industry. What you want is to add a light pole with a nut and a bolt, and you can use an electric motor to turn the bolts and the nuts.

It should be ok, but it's a little bit of a problem, which is that you have to be able to use an electric motor and you have to have a lot of power or you can use a decelerator,

Q:Simple manual lifting mechanism, a nut a bolt can

Handle is fixed below the floor below need not fixed, it is not fixed under the base plate is fixed, the floor below the retaining common shim fix the quotas for marketing or for cap.

Q:What standard elevator platform needs to go to the special equipment inspection to report

Hoisting machinery, it is to point to used for vertical lifting or vertical and horizontal moving heavy mechanical and electrical equipment, its range is rated lifting weight greater than or equal to 0.5 t elevator; The weight is greater than or equal to 1t, and the lifting height is greater than or equal to 2m crane and weight bearing form fixed electric gourd

Q:Safety operation of hydraulic platform

Purpose: this procedure is used to guide operators to operate correctly and use hydraulic platform equipment. Two procedures: 1, the parts should be inspected carefully before they are work lifting platform, key check whether the screw connection is reliable, hydraulic pipe leaks, loose wires contact with and without, breakage, and so on and so forth. 2, lifting platform lift, put the leg in the four corners, four leg should be firmly supported on solid ground, dispatch work mesa to state level (visual). Turn on the power, the indicator should be on. Then start the motor, pump work, drop one or two in the air, check the parts and then start working again. When the temperature is below 10 ℃, should make the pump running 3-5 minutes, confirmation of oil pump work can be carried out. 3, homework personnel enter the platform after the guardrail doors should be closed, with bolt, tied on safety rope, the center of the load (people stand location) should be in the center position of workbench face.

Q:Diablo ii flame volcanic mission will not be able to jump

Push the pole to the right to climb quickly to seize the board on the wall, press the left key to left, after the magma press e and ran to the front of the counter, jumped to the table according to move to the left along the plate on the plate

Q:How much is the 8 square meter tatami mat

Look at the material you choose. Eight is not too small. It is estimated to be around 5,000-1w, without a lift