Q:I live in an older brick bungalow on what's become a rather busy corner. There's a lot of foot traffic that goes by within 10 ft. of my den windows, where we spend most of our time. I don't like feeling so exposed, and passersby can be loud at times. The two windows are about 3' x 5'. I really wish the bottom of the windows weren't so low. Half-height windows would be sufficient. What would be the most inexpensive and aesthetically pleasing solution? I can't afford to just tear out a brick and plaster wall and rebuild it.

Use insulated drapes. Make sure that they cover the entire window and keep them closed.

Q:How can we paste the perfect

The greatest difficulty in the baked, as long as you can be baked on the paste is very perfect, if the baked even posted on the edge of the fold even if there is no good look. There is the time to close the door when the door should be closed, do not let the dust into the compartment, the glass to clean, pull the film when the contact area of the smaller contact the better.

Q:Decoration of the ground protection film

Long service life PVC combined with knitted cotton greatly improved the life of the ground protective film, far beyond the use of similar products

Q:Wall decoration stickers how to use

1, first selected stickers paste the location, and then to paste the location - walls, glass, furniture, etc. above the dust or grease wipe clean. 2, hand-held stickers first look at how to paste the best look. 3, began to paste the time, then paste the middle and then press the left or right. 4, if posted after the feeling of dissatisfaction with the position, please slowly tear off for the location and then paste, if posted with a bubble on the needle with the needle about the air can be removed.

Q:frnds for my office entrance door kindly suggest, shall we go with decorative glass film on glass doors or with etching or frost work on glass. which one is better?

etching is better... more expensive and much classier...

Q:I am trying to cover windows in a classroom with decorative scenes and at the same time allow as much light inside. Scenes like the sky with coulds would be an example. It could also be educational scenes if posssible.

The cloud one can be picked up at Home Depot. They sell them over by the blinds.

Q:film is for decorative reason, not for some protection

wash the window then mist the window with water and the back of the film apply it to the window then mist the front of the film and using a squeegee work the water and bubbles out of the film wipe up excess water let dry

Q:Home color film is how to paste the wall

With a light soapy water, the film and the walls are spray wet, by the top slowly paste, while the side with a ruler to push, so as not to have bubbles, adjust the location, dry on the OK, if the middle of a bubble, gas.

Q:Pvc wood decorative film is how attached to the furniture

How to use pvc grain decorative film? I am here to write the following: ?????? 1.PVC wood grain, plain film is suitable for hand stickers, flat paste and vacuum plastic two different materials ?????? 2. flat paste of the material suitable for use or mechanical roller paste paste, ?????? 3. Vacuum plastic material suitable for vacuum blending, blister material is usually temperature above 120 ℃. ?????? 4. PVC veneer commonly known as plastic veneer, is a very wide application of surface decoration materials. According to the pattern or color can be divided into monochrome or wood, according to the hardness can be divided into PVC film and PVC film, according to the brightness can be divided into sub-light and high light. According to the veneer process can be divided into flat paste decorative film and vacuum plastic decorative film. Among them, PVC film is generally used for vacuum blister production process, high-end office furniture, cabinet doors, bathroom doors, home decoration sets of doors, decorative panels are often used PVC surface vacuum veneer veneer.