Q:The electric kettle can be used in the U.

Electric kettle can not be used in the United States, the United States voltage 120V, 60HZ. Don't take it. American appliances are also cheap. You can buy them over there.

Q:What are the problems with electric kettles in the market?

The plastic material does not use qualified food grade products, open the lid of a plastic taste

Q:Where is the temperature sensor in the electric kettle?

The thermostat is usually switched together! Conventional electric kettle switch is divided into two main structures, one is attached to the pot low heating plate, in order to avoid dry burning.

Q:How to buy electric kettle, pay attention to what details?

See the details of appearance: electric kettle can highlight the details of an electric kettle brand is good or bad, and can identify the details from the electric kettle is general electric kettle details are: open the cover of the electric kettle is in line with the way their own habits; electric kettle base is Hukou slip; whether shaving hands, now the electric kettle on the market most of the national security level of plastic. The plastic is thick and relatively smooth and bright and beautiful appearance. Purchase should pay special attention to its sealing condition, there should be no leakage, leakage phenomenon. If the heating element can be seen, attention to buy the heating element and the kettle body interface should be installed firmly and reliable seal, hand gently touch the heating element, the check assembly is strong, should not have loose phenomenon.

Q:How can the electric kettle be repaired without heating?

Without heating indicator lights have bright any is bad heating tube, if not switch is broken. Remove the electric heating tube and use the multimeter R * 1 to measure the electric heating pipe. If the resistance between the two feet is infinite, it is the fault caused by the burning of the electric heating tube.

Q:Why can't the electric kettle be used?

Use a screwdriver to open the lid, make a contact with sandpaper

Q:How can we prevent the electric kettle from drying and burning the thermostat?

When the electric kettle is not dry, the thermostat needs to be replaced in time, and a new dry burning thermostat is needed.Otherwise, in case of dry fire, the heating system of the electric kettle will be damaged. Then the whole kettle would be scrapped.Anti drying temperature controller is an important electronic component to prevent the heating element of electric kettle from being damaged.

Q:What do you mean by the three heavy safety protection of electric kettle?

Electric kettle when you buy what is said, the water power off automatically, anti dry ah these, in fact, the heating kettle on the heating pipe, the heat dispersion to the aluminum plate to transfer heat to the heating plate, those things are all manufacturers said, the water is cut off the pot, a steam pipe, the water boiled water vapor through the tube on the bottom of the thermostat, when the temperature reaches a certain degree automatically broken, anti dry ah is also heating plate temperature will also increase rapidly, it is easy to burn the disc, all electric kettle has the thermostat. What is the protection of several businesses with the publicity

Q:Working principle and maintenance of electric kettleWhat is the principle often bad place where ah

Therefore, the safety protection device of the electric kettle is designed very scientific and reliable, which is the three heavy safety protection principle of the electric kettle

Q:Why does the electric kettle trip when the electricity is on?

If it is dry burning prevention electric kettle three core, the lights outside the stickers off, on both sides of the screw with a screwdriver to remove the socket can open the cover, put the lamp down from the housing, there are three screws on the base, use a screwdriver to remove the screw down, so the heating kettle the tube and the base left, then the metal ring screw cap power base on the unloaded, the bottom cover is open with a small screwdriver, check the internal power supply part is copper wire and the zero line contact line or the phenomenon of the contact position away from it, you can continue to use the re installed.