1) Big LCD display
2) Ultra-quiet design
3) 24-hour timer
4) Big LCD remote controller
5) Fault self-diagnosis function
6) Efficient energy saving
7) Ultra-strong EMC
8) Sleeping mode function
9) Independent dehumidification (Dry mode)
10) Constant fan speed control
11) 360-D blowing
12) PG motor
13) CE CB TUV GS etc approvaled
14) Double-muting technology
15) Auto-defrost function
16) With 3m connection copper pipe and 4m electrical cables
17) Auto-restart function
18) Galvanized outdoor casing with anti-rust layer
19) Auto-cleaning functions
20) Blue fin/ Gold fin for evaporator and condenser
- Q:What is the life general air conditioning
- Life to see what air conditioning gree is ten to fifteen years.Ways to extend the service life of air conditioning: Using air conditioning should not frequent switch. Don't cry because it is the room temperature reached demands value or higher than the value, and often start and close the air conditioner, and shall let the air conditioner through the temperature controller to control the startup and shutdown. Air conditioner when not in use should be shut off the power and pull the plug. Air conditioning in any downtime due to whatever reason (e.g., suddenly loses power, artificial downtime, etc.), due to the length of time a general air conditioner have delayer (delay time about 3 minutes), then this kind of air conditioner downtime is immediately after the boot, but need to work after 3 minutes. But for no time delay of air conditioner, downtime can't immediately after boot, be sure to after about 3 minutes, to open the air conditioner again, starting current is too large, otherwise may cause burning fuse, or even burn down compressor motor consequences. Especially pay attention to the effective use of the timer. Sleep and go out, please use a timer to make it only works in the necessary time, in order to save electricity.
- Q:How to connect household air conditioning pressure gauge
- 1) check for the temperature of the fluid tube and muffler and condensation. Start the air conditioning runs under the condition of refrigeration 20 min, if any condensation on the outdoor unit back to the valve and the muffler, muffler fingered temperature was lower than that for the temperature of the fluid pipe, shows refrigerant in the system is enough, air conditioning running normally. Has one of following cases, indicates lack of refrigeration: (1) for the liquid condensation tube, muffler condensation; (2) for liquid pipe frost; (3) for liquid tube not dewing cool, muffler, nor too cold; (4) for fluid pipe and trachea is not cool. (2) measure the pressure of the valve in the back. Add the pressure gauge connected to air conditioning low pressure Angle valve inlet, measuring its operation at low pressure, under normal circumstances, when the environment temperature is about 30 ℃, refrigeration operation of low pressure is 0.45 ~ 0.55 Mpa, in heat pump air conditioning heating runtime should be 1.8 Mpa, if under the pressure, shows lack of refrigerant. The lower the pressure, the greater the leakage. If the basic pressure, explain refrigerant has. (3) fill nitrogen pressure (1.5 Mpa nitrogen filling the), observe the four two connecting pipe joint, gas liquid valve stem, and whether there is oil stains in areas such as the liquid mouth. There are oil stains for leaks. (4) using the leak detector to find the general part, and then coated with soap and water, if there are air bubbles appeared, to be funnelled namely. (5) of the heat pump air conditioning indoor unit and the connection part of pipe leak detection should be under the heating operation state, because of the inspected parts under high pressure, easy to find funnelled.
- Q:The working principle of air pressure switch?
- Jetta air conditioning 3 thread working principle of the pressure switch: (1) three lines, a 12 v. (2) the other two root is a high voltage switch, one is the atmospheric pressure switch, pressure is too high will disconnect the compressor electromagnetic clutch. The three lines of air conditioning plug connected to the plug: (1) wire (mostly red or brown) plug or socket on L interface, (2) the zero line (in blue or green) on N interface, (3) the ground wire (double color) on E interface.
- Q:Outside air conditioning machine how to cleaning?
- Air conditioning separate-bodied air-conditioners design considering the outdoor environmental factors, need not wash, the sun wind rain naturally clean, will not affect the use.
- Q:Household central air conditioning and the wind pipe bender is the same function
- Before you install the wind pipe must be carefully read my above words. This family central air conditioning not typhoon machine take several rooms. A bracket type wind pipe bender can, but for side, a room for a small wind machine, each machine separate control. So the variable-frequency from indoor and family central air conditioning indoor decoration effect is the same. It's just machine technical degree is different. Economy is outstanding, is the enjoyment of the central air conditioning. Weakness is outside the machine, but now will have air conditioning units, and it is not a problem. About the brand I'm sorry, I can't evaluate other brands. Advised to choose a domestic first-line brand, well-known brands. Only with you simple say beauty brands. I do beauty of wind machine and inverter type central air conditioning for seven years, a bracket type wind mill technology content is low, the product technology is mature and stable. Frequency conversion air conditioning is one of the earliest domestic brand technology make the beautiful, which is why beauty is the main reason of frequency conversion technology, the stability of products, and the economy, the cost performance is very outstanding. Of course you can look at from the local market. Ownership from the product of the market, brand awareness, quality after-sales service and other relevant information to refer to your own choice. If you have any questions please ask.
- Q:What kind of air conditioning the save electricity?
- Haier can also, but the brand is not the usual machine electricity savings, but to use correctly, the refrigeration temperature at 26 degrees, it is not hot nor cold, and don't put air conditioning in the near the sun can shine, close the doors and Windows during the day, try to pull a curtain, reduced sunlight can save a lot of electricity
- Q:Which band air-conditioning energy efficiency is best
- Because power consumption is certain. Why power consumption must be? This is the key to the problem, because is a fixed frequency compressor, power consumption must be so, manufacturer just increases the refrigerating capacity. As a result, it can be seen that air conditioning can effect comparing high aren't necessarily must save electricity. Is variable frequency and frequency conversion air conditioning compressor, will surely save electricity, but beware, frequency conversion air conditioning must choose dc frequency conversion air conditioning, can save electricity above 50%.
- Q:The effect of air conditioner expansion valve
- Is the role of the expansion valve throttling depressurization, your process is right
- Q: the home of air conditioning ark of wire is to use a few square?
- 1, home air conditioning ark can choose 2.5 mm square copper soft plastic wire, this is according to the needs of ark of air-conditioning installed power, coefficient, operation time, environment and fire safety factors are used to determine; 2, decorate in the family, according to the specification shall be installed by a licensed electrical work is responsible, it involves the wires, switches, sockets, lamps and lanterns, track laying away diameter, component location, maintenance and other related security measures in the future. 3, toilet bath bully optional 2.5 mm square copper soft plastic wire, because the bath bully 4 bulb power is larger. Family is the harbour of happiness, the laying of electric circuitry for once, to be on the premise of safety, with practical as fundamental, or Suggestions for the measured point
- Q:What is the working principle of air conditioning?
- In simple terms, is the indoor quantity of heat, through the refrigerant to outdoor putting off Detailed process of refrigerant in the evaporator (indoor machine) evaporation heat, namely will indoor heat absorbed (refrigerant why will evaporate, because its boiling point, like liquefied petroleum gas, liquid in the flask, leaking out to turn into a gas) Absorb the heat, and then to the compressor, through compressed into high temperature and high pressure gas, then to the condenser condensing (outdoor), condensation is the process of heat release, and then liquefaction, under certain pressure, otherwise not liquefaction After liquefaction, refrigerant in capillary pressure, and then to the evaporator (indoor machine) evaporation heat, so the cycle, became a refrigeration system Summary, evaporation heat, condensation heat, evaporation heat, condensation heat... The cycle
An enterprise without innovation is one without soul, the enterprise without core technology is one without backbone, when one has no backbone, he can never stand up. We will still insist on the development of independent development, independent innovation, and original brand development, and aim to create an international leading home appliances and power enterprise and a long-lived world-class brand.
1. Manufacturer Overview
|Annual Output Value
||Above US$100 Million
||10.00% South America
10.00% Eastern Europe
10.00% Southeast Asia
10.00% Mid East
10.00% Eastern Asia
10.00% South Asia
10.00% Central America
2.00% Western Europe
||ISO 9001:2000;ISO 14001:2004
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||91% - 100%
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range