Roof Gutter Screens Mesh/Gutter Covers

Specifications:

Long way of mesh :12.5 to 200mm

Short way o fmesh:5 to 80mm

Thickness:0.5 to 8mm

Surface treatment: galvanized, pvc coated 

Sheet length from 600 to 4000mm and sheet width from 600 to 2000mm.

Installation

Step 1: Place the Diamond Back into the gutter with the lip side toward you.

Step 2: Push back on the product until it pops in or locks into front lip of the gutter.

Step 3: Designed with a tab to overlap the next piece.

Step 4: Continue and repeat steps 1, 2, 3 until you get the end cap.

Step 5: Once you are to the end cap put in a zip screw to close the end and keep debris and birds from getting in the gutter

Note: If you get to a place where there is not a hidden hanger to support the product you should add 1 ½ inch screw to hold the product in place.

Features:

• Contoured and low profile spring-tension design fits any sized gutter. Spring tension fit also resists dislodging from severe weather.

• Fits applications such as wood shake shingles, slate, low slope flat and most non-asphalt roofing.

• Powder-coated galvanized steel resists rust and UV degradation. Steel material and patented structural design resist collapse due to debris load.

• Small hole design protects against clogging from leaves and debris.

• May be installed on any pitched roof without shingle disturbance.

• Efficient design to accommodate most budgets.

 Photos: