Q:Where should fire emergency lights be installed?

Two, fire control room, fire pump house, own generator room, power distribution room, smoke prevention and smoke evacuation room and other rooms which need to work normally during the fire;

Q:What is the implementation standard of the new national standard fire emergency lamp?

in order to ensure the fire emergency lighting power supply is reliable, has the condition by low voltage power supply of emergency bus line, when the diesel generator for emergency power, as long as the generator is put into use, it is to ensure the power supply of electricity.

Q:Is the wall wiring for fire emergency lights and safety exit signs piping or iron pipes?

the fire separation zone must install fire doors must be equipped with double automatic system, with the fire regulations.

Q:When will the car emergency lights be used?

on the road failure or traffic accidents, should open double flashing lights, to remind the past vehicles pay attention to safety.

Q:How many W bulbs are used in emergency lights?

battery life: more than four years (or 500 charge and discharge); emergency time: 90mih (special note need); power: 20W.

Q:Under what circumstances will fire emergency lighting be on?

There are more than two light sources in the lamp emergency lighting, and at least one can provide illumination when the normal lighting power supply fails.

Q:The emergency light went off suddenly, so it suddenly lit up

Special case: when the grid voltage is below 187V, it also enters the emergency state.

Q:How to install emergency light?

. The spare lighting that continues to work is usually located in the distribution room, fire control room

Q:What is the power of emergency lighting?

emergency transfer time: less than 2S; 6, emergency light effect is not less than 50LM;

Q:How to turn on the fire emergency light?

. If you want all the emergency lights on the corridor to turn on, switch off the power switch.