Pssager Car Radial Tyre 206/60R15 LY688

Ref Price:
Loading Port:
Qingdao
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Size:206/60R15 LY688

Application:The tyre is used to Passager Car.

Pattern Characteristic:

1,Shark Fin Tread Pattern

2,The six horizontal steps equally distributed can effectively decomposs the pumping noise source,reduce noise,greatly promote the rigidity between the tread pattern blocks and eliminate sundries in the grooce.

3,Split Tyre Shoulder Block Design

4,Small Knurl Design on Side Wall of Groove

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Somebody that knows about car tires?
It is physically impossible to mount a 18 diameter tire on a 20 inch diameter rim. You have 18's. Secondly, any tire with an sidewall aspect ratio of 55 or less is considered by most a low profile tire.
Q:What is the effect of the tires on the car tires?
Look at it, you will find the car tires have such a pattern. This is not to look good, but to ensure the safety of vehicles driving. Why do you say this way? If the car is only on a very dry road, the tires do not pattern is also very safe. Can be a rainy day, no pattern tires are easy to slip, this is because there is a thin layer of water film between the road and the tires, water film to reduce the friction between the tire and the road. At this time, the car will be staggered to open up, would like to stop but not stop. If the tires are patterned, the water will drain from the groove of the pattern, and the tires and the ground are still tightly attached together, so it is not easy to slip. Vehicles in the city, tires on the pattern are generally straight jagged, it can help eliminate the car when the noise emitted. In the field of vehicles, tires on the pattern is deep and wide, can be tightly "bite" live on the ground, even in the snow, not easy to slip.
Q:What is the meaning of car t and tr?
The car tire R says it is a radial tire, TR-Typer precision tire.
Q:What is the standard for car tires?
Tire type and specification: International standard tire code, expressed in millimeters as a percentage of section height and flatness, followed by: tire type code, rim diameter (inch), load index (permitting bearing quality code), promise With speed code. For example: 175 / 70R 14 77H 175 represents the tire width is 175MM, 70 means that the flatness of the tire cross section is 70%, that is, the cross section height is 70% of the width, the rim diameter is 14 inches, the load index 77, the allowable vehicle speed is H level
Q:Can car tires cut?
Tire side scratches are recommended for timely replacement. Because the side of the tire is relatively weak, if the side scratches almost impossible to repair, such as continue to use, there is the risk of puncture, there are security risks.
Q:How is the car tires and hubs connected?
Should be the spline shaft shaft head (that is, bearing) fixed the wheel, the wheels on the installation of tires.
Q:The right side of the car tire wear serious problems
The reason for unilateral wear is due to tire inclination or digging. You can correct the mechanical failure by making four rounds of positioning. Professional tires shop can provide this service.
Q:Are used tires safe to buy?
For the best answers, search on this site Chances are that the used tires have enough wear on them that you won't really be saving much money. You will have to replace them far more often than the new tires. I also seriously doubt that the used tires come with any factory warranty. Over all you would be better off just getting the new tires.
Q:Normal car tires generally play how much qin gas?
Domestic passenger vehicles common tire pressure unit is "Bar", retail stores sometimes say how much "kg". 1, tire pressure should be how much to determine the value of the depot recommended. Of course, it is recommended that you measure the tire pressure in the best room temperature environment. 2, the standard pressure can usually be found in the following: vehicle user manual, cab door (near the B column) next to the label, the driver's seat next to the drawer, fuel tank door. The above mentioned vehicle tire pressure recommended value refers to the cooling tire pressure. Defined as follows: at least three hours after stopping or no more than 2 km of tire travel. If the tire pressure can only be measured at the time of the hot tire, subtract the measured tire pressure value by approximately 0.3 bar (= 4 psi) as the tire cooling inflation pressure. For example, the tire manufacturer's recommended inflation pressure is 2.1 bar, and if the tire pressure measured at hot tires is 2.2 bar, it is necessary to increase by about 0.2 bar at hot tires.
Q:where to change tires?
The correct tire size for your vehicle is P205/65R15 92V. Because your vehicle as the V6 it is highly recommended that you not step down to a tire with a lower service description than 92V (like the more common but inferior 92H or 92T for example) as that will reduce the handling and braking capability of the vehicle. If you want cheap tires then you should not have bought the V6 model with its special tire requirements. Tires I can recommend for this model for someone living in the Chicago area would include: BF Goodrich Traction T/A (mid-priced and long wearing). Michelin MXV4+ (the tire that came on the car when new, not cheap in any way). Continental Extreme Contact (relatively cheap and good in snow but don't wear well). Kuhmo Ecsta ASX (cheapest of the bunch). It is always best to replace all 4 tires at the same time so you have equal traction at the front and rear axles and can maintain a proper tire maintenance schedule. If you must replace only two tires the new tires absolutely should be installed on the REAR AXLE as per industry guidelines. Michelin Tire was recently sued successfully for $34 million because a shop put 2 new tires on the front and the car spun and turned one of the passengers into a quad. If your tire installer does not put them on the rear axle they are quite frankly not knowledgable industry professionals and should not be entrusted with so much as checking your tire pressures.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range