Q:Construction in the wall and the beam at the junction of nail wire mesh what role

To enhance the capacity of some of the ground, in the processing workshop, garage and other places on the ground load larger room, wire mesh can improve the overall structure of the ground layer strength, to avoid the ground cracking, fall and so on.

Q:How does the "jagged" on the back of the knife cut the barbed wire?

Army knife sawtooth is mainly to eliminate the internal strength of the knife body, processing to be quenched, there are jagged, quenching time to eliminate the knife's internal stress, is more solid knife body, and in special times as a saw, do not have to cut wire mesh,

Q:Will the gray sand brick wall is full of hanging wire mesh?

Do not cover, mainly the block and concrete frame at the junction to hang 300mm wide steel wire mesh, barbed wire is in the bearing beam, column with the late brick between the wall of the nail,

Q:Wall tiles how to hang iron wire mesh

In the wall more nails, and then use the cement bonded wire mesh can solve the above problems;

Q:This material of the barbed wire in the water I do not know how long?

Protection and shielding effect of the outermost layer of glue is insulated, the role of fire inside some iron / copper layer, is the protection and shielding effect of the innermost copper wire, is the current effect, used for conductive transmission

Q:Is the warm tube laid on top of the steel wire or below?

To warm the pipe is in the wire mesh above, because the main wire mesh is the role of a fixed warm tube.

Q:What is the mesh in the wire mesh specification?

The number of wire mesh refers to the number of holes of 2.54 cm. The unit used to express the mesh in the mesh product specification is hole / cm or line / cm.

Q:What is the barbed wire fence? What is the general specification?

Anti-destructive performance, good steel, handsome in appearance, wide field of vision, easy to install, feel bright and relaxed.

Q:Barbed wire mesh 20 mesh and 30 mesh what is the difference

The mesh count refers to the number of holes of 2.54 cm. The unit used to express the mesh in the mesh product specification is hole / cm or line / cm. In countries and regions using imperial units of measurement, the mesh size is expressed in holes / inch or lines / inch.

Q:What is the effect of the wire mesh on the floor

to speed up the heat: because the thermal conductivity of iron is relatively strong so that the ground is very uniform heat.