Q:LED display power supply how to configure how many units with the plate is calculated.

According to the unit board power calculation, P10 monochrome in general 10 to 12 blocks, indoor monochrome 12, indoor color 6, full color, then ask the unit board manufacturers, a board of how much power. And then calculate their own bar.

Q:What is the difference between an LED display and an LCD monitor?

LED is Light Emitting Diode. LED applications can be divided into two categories: First, LED display; Second, LED single tube applications, including backlight LED, infrared LED and so on. Now on the LED display,

Q:LED display how to install it?

This installation and cantilever installation similar, the same application, the screen body with a cabinet design, suitable for indoor, semi-outdoor screen body.

Q:LED display more than the size of the area must be 380v

LED display itself only need low-voltage DC power supply, whether it is 380V or 220V need to go through the buck and rectifier, which is the screen does not matter. Whether it is to use 380V or 220V depends entirely on the load balance of the power grid considerations, which depends not only on the size of the display, but also on the local grid capacity. In general, LED is weak devices, even if the display area and then large, the total power is also less than where to go, so you can use 220V single-phase power supply, but the power supply cable cross-sectional area to be larger, but the power circuit Much simpler.

Q:LED display screen appears black? How to solve?

Of course, it may be the graphics driver is not installed or installed is not complete, you can download the driver to install the upgrade to the graphics driver can be. Microsoft may be the system of the problem, you can directly replace the system, and then start the computer to see if there is a black screen failure.

Q:Led display speed how to tune

If you need to display the time / temperature, select the "Show time / temperature" option, and then click the "Time / Temperature Settings" button to pop up the following dialog box to set the time, temperature display format, color, font size, display length.

Q:LED display a board dark light how is it?

Visual power cable, unit board between the 26P cable and power module indicator light is normal. The following are the same as the "

Q:Led display brightness is not enough because of what are the reasons

If the screen is a very small piece of time is sometimes very dark, the unit is usually a problem, or drive IC problems, to replace. If the entire LED screen has become very dark, if the circuit board control system problems, it is recommended to restore the factory mode. If it is caused by the graphics driver, it is recommended to update or reinstall the driver.

Q:IPS screen and LED screen difference

LED is the backlight, longer life, lower cost, with TN screen you slightly higher performance, LED performance is good, high dynamic contrast. The disadvantage is too bright, a little hurt eyes. Now the mainstream are used LED screen, short response time, suitable for playing games.

Q:16: 9LED What is the approximate size of the display?

Ie the effective screen is the diagonal size representation. And the aspect ratio of 16: 9 is that we say widescreen, the unit is inches. From this we can calculate the scale factor. (The old TV used in the ratio of 4: 3 also we said the narrow screen)