P10 LED Electronic Rental Display CMAX-P10
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- -
- Supply Capability:
- 10000000 M2 PER MONTH m²/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
P10 LED Electronic Rental Display CMAX-P10 :
1. Wide viewing angle
2. IP65 protection rating.
3. Fast and easy to assemble and dismantle.
4. High grayscale (15 bits) with perfect visual performance.
5. High reliability and long lifespan (MTBF ≥ 10000 hours).
6. Special design which can make our LED panel both front and rear side maintainance accessible. This will greatly cut down the maintain cost.
we provide overall communication systems from the stree,to the lobby to the loading dock,from the foyer to the meeing room.our display systems are everywhere:manufacturing plants,transportation/highways,commercial and retail stores,restaurants,billboards,theaters,scholls,and gaming and lottery
our indoor or outdoor displays can be maded to custom fit your application or you can choose from of different sizes.
P10 LED Electronic Rental Display CMAX-P10
Pixel Pitch | 10mm led display |
Module Size | 320mm× 160mm |
Pixel Density | 10000 dots/m2 |
Pixel Configuration | 1R1G1B |
Pixel Resolution | 32 x 16 pixels |
Cabinet Material | Steel |
Brightness | ≥ 5500nits |
The Best View Distance | 5~50m |
The Best view Angle | Horizontal:100 ± 5°,Vertical:55 ± 5° |
Max Power Consumption | ≤650W/ m2 |
Drive Mode | 1/4 Scan |
Refresh Rate | ≥300Hz |
Control System | Synchronization |
Input Voltage | 220V±15% |
Data Communication | RF,S-video,RGB,RGBHV,YUV,YC,COMPOSITION |
Work Life | 100,000Hours |
Packing | Wooden case |
- Q:Led display point density is what it means
- LED display density refers to the LED display per square display the number of pixels, such as P10 model LED display is 10,000 pixels per square point, P16 model refers to the display refers to 3906 pixels per square point.
- Q:Led display and led lighting What is the difference?
- LED display and lighting are LED light-emitting diodes as light source. The difference is that the application of LED: LED display using dot matrix, the combination of different colors of light-emitting diodes, through the control system, power system, signal system and other forms of control, composed of LED device array display screen; and LED Lighting is a monochrome diode excitation, the pursuit of brightness, gray and white balance.
- Q:LED electronic display and P have anything to do
- P generally represents the pixel pitch, and P followed by the value of the two mainly refers to the distance between the pixels, usually called the point spacing. And the smaller the value of this point spacing, the higher the unit pixel, the more clear the display screen.
- Q:Led display support what video format
- LED display support video format depends mainly on the LED display control software, generally supports a variety of formats of graphics and text pieces: TXT, DOC, RTF, AVI, JPEG, MOV, MPEG, DAT, VOB, BMP, JPG, TIFF, GIF, FLI, FLC, RMVB
- Q:LED display how to install it?
- LED display according to the application of different areas, divided into a variety of installation methods, there are: fixed installation, rental hoisting, stadium fence installation.
- Q:LED display more than the size of the area must be 380v
- LED display itself only need low-voltage DC power supply, whether it is 380V or 220V need to go through the buck and rectifier, which is the screen does not matter. Whether it is to use 380V or 220V depends entirely on the load balance of the power grid considerations, which depends not only on the size of the display, but also on the local grid capacity. In general, LED is weak devices, even if the display area and then large, the total power is also less than where to go, so you can use 220V single-phase power supply, but the power supply cable cross-sectional area to be larger, but the power circuit Much simpler.
- Q:LED display screen appears black? How to solve?
- The power is broken, the card is broken, the configuration is wrong, or may be sent to the empty text, it may be root you do not give electricity
- Q:Led display speed how to tune
- All need to display the data are ready, the "send" button to send data, select the need to send the frame and set the starting address, the point can be sent
- Q:IPS screen and LED screen difference
- Simply said IPS screen perspective wider, more wide color gamut, suitable for mapping and see high-definition movies, the drawback is a higher delay, play the game is not to force the shadow. Suitable for making pictures or watching movies.
- Q:LED display power can not be displayed properly
- Check and confirm that the serial cable used to connect the controller is loose or off. (If the black during the loading process, it is likely that because of this cause, that is, during the communication process due to loose communication line and interrupted, so the screen black. Do not think that the display body is not moving, the line can not be loose, please It is important to check the problem quickly.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
P10 LED Electronic Rental Display CMAX-P10
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- -
- Supply Capability:
- 10000000 M2 PER MONTH m²/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords