Q:How is Allegro embossed aluminum-plastic plate is an aluminum-plastic plate, who can describe in detail?

Athena embossed aluminum-plastic plate is the use of coated aluminum plate by a special fine process to suppress a variety of convex and convex pattern of aluminum.

Q:OKorder aluminum-plastic composite board where to sell?

Cloud like building materials have aluminum-plastic composite board sales

Q:I am in Kunming, but there is a site in OKorder side, want to buy aluminum plastic plate to decorate the store, there is no authentic aluminum plate manufacturers ah

Kunming Yulong Road, there is a way to sell aluminum-plastic plate, you can ask

Q:What are the folds of aluminum

Aluminum-plastic composite board slot can generally open V-groove, U-slot, etc., several typical slotted as shown in Figure 1. Aluminum-plastic composite panel plate in the cutting board to take into account the size of the fold , Generally add about 25mm on each side. Cut the composite board needs four sides of the planing slot, that is cut to a certain width of the inner layer of aluminum and plastic layer, slot depth must be strictly controlled in the front aluminum plate at least 0.3mm thick plastic core To ensure that the aluminum-plastic composite panels have sufficient toughness to prevent the fold at the aluminum skin fracture, and then folded into a 90 ° angle, so the board surface weight and curtain wall at any time will be positive and negative wind load pressure by the four sides 0.5mm aluminum plate to bear, therefore, slotting is the aluminum-plastic composite panel panel of the weakest link, but also under the wind load under the first destruction of the site

Q:I want to open a small aluminum-plastic plate factory, how much money

Production of aluminum-plastic board products, the need for pretreatment, painting, composite three sets of equipment, this down 800,000 on it, if it is a small factory, then you can find third-party manufacturers to paint, you can only on the composite line, so Single equipment 50 million enough.

Q:Can aluminum-plastic composite plates be bent 90 degrees?

In the process of forming the aluminum-plastic plate material, the 90-degree right angle after opening the slot is intended to be a general processing method, and the greater bending angle is greater than 90 degrees and there is no problem.

Q:What is the difference between aluminum and aluminum curtain wall aluminum veneer? That cost is high!

Aluminum veneer life of more than 10 years, and meet the board life is usually 3-5 years

Q:Aluminum plate and aluminum plate which is good?

Are now the main decoration materials, can be used, the cost of a little difference, some more beautiful aluminum-plastic board, you can also consider the aluminum plate. In short, their satisfaction is good.

Q:What is a composite function building material?

Aluminum-plastic composite board is a chemically treated coated aluminum sheet for the surface material, with polyethylene plastic as the core material, in the special aluminum-plastic plate production equipment from the processing of composite materials.

Q:How to deal with the leakage of aluminum-plastic panels

If the aluminum-plastic plate itself is hard to pierce or peel a class, then you need to replace the material.