Q:Performance index of PE protective film

2. low viscosity protective filmCharacteristics: thick (0.03m + 0.003), width (less than 1.3), high (100-1000), substrate (PE), peel strength (10-20g/cm), temperature (60), stretching rate (>400)Purpose: tack stability, good adhesion, then peeling performance is good, no glue residue phenomenon for steel mirror plate, titanium plate, smooth plastic, silk screen, Ming brand and so on.3. medium and low viscosity protective filmCharacteristics: thick (0.03m + 0.003), width (less than 1.3), high (100-1000), substrate (PE), peel strength (30-50g/cm), temperature (60), stretching rate (>400)Purpose: tack stability, good adhesion, then peeling performance is good, no glue residue phenomenon for furniture Polaroid plate, stainless steel plate, ceramic tile, marble, artificial stone and so on.

Q:How to remove the protective film from the stainless steel thermos cup？

Heating the protective film with electric hair drier so that the film will separate from the cup. Then you can directly tear it off.

Q:If the keyboard protective film is too big, do I need to cut it?

No need to cut it. You can just use the whole film to cover the keyboard.

Q:When decorating, enter the door to protect the film, with what glue paste? Usually use sealing tape, a lot of time paste is not smooth, seriously affecting the appearance and image of the company. But the glue needs to be cleaned easily after the decoration is finished! Seek advanced or expert pointing!

The door door is made of inkjet material, which is still sealed with tape, and will stay flat as much as possible. Some outside may use soft protective film, but most will still use adhesive tape to seal, and the possibility of using glue is very small.

Q:What are the ways to remove the stainless steel protective film?

5. With hand cream. First, the surface of the printed products tear off, and then put some hand cream on the top, slowly rub with your thumb, rub for a while, you can rub the stainless steel protective film on the residual gum are rubbed down. Just slow down. Hand cream is a kind of grease, which is not compatible with gum. Remove glue is to use this characteristic.

Q:How to remove the protective film on tiles?

The protective film on ceramic tile is long, can not be wiped off, how should be cleaned?

Q:How to remove the protective films on electrical appliances after using for a long time?

You can use gasoline or use electric hair dryer to blow the film for a while. It will get very easy to remove.

Q:PVC protective film reacted with the plastic on which it's coated. Why did that happen?

It's about the glue.

Q:How can the protective film on the burglarproof door be removed after sun exposure?

The first chunk by hand, or small pieces of plastic softening under the opposite side of the membrane and fine flour with wind in the above

Q:What kind of glue is suitable for protective film used in the decoration of entrance doors?

There's a kind of appropriate film with big rolls. But it's very expensive. It's a little similar to the rolled protective film used on screen of mobile phone.