Product Description:
1:38℃ SECURE stop: Button for blocking the temperature at 38 ℃
2:EASY system: One mono - block internal cartridge, which you can take out
and put back in a matter of seconds.
3:ECO-stop: ECO-stop function limits water flow, with a savings of up to 45%.
4:38℃ACCURATE control: More accurate, stronger, and more resistant.
Guarantees greater safety maintaining the water temperature constant with
more accuracy.
5:FAST reaction: Very fast reaction time and temperature balance
6:WATER saving: Going from cold to hot uses up energy. Making this process
quicker means using up less.
Technical reference:
Material | Brass main body and zinc alloy handle |
Material Analysis | Cu≥ 59% |
The Thickness of chrome plating | Nickel>8um Chrome>0.2um |
Water flow | Bath/shower mixer ≥ 18L/min |
Operating pressure | 0.05Mpa-0.8Mpa |
Recommend pressure | 0.1Mpa-0.5Mpa if>0.5Mpa Installation of a flow reducer is recommended |
Cold water temperature | 4℃-29℃ |
Hot water temperature | 50℃-80℃ |
Temperature range | 20℃-50℃ |
Security stop | 38℃ |
Cold water supply failure test | Within 5 seconds after cold water supply fails, outflow rate automatically drops to 1.9L/Min, outflow quantity:≤150ml |
Life test | CSA B125-98 ASSE 1016(=100,000 cycles) |
Outflow temperature Auto-adjusting sensitivity | When inlet water temperature or pressure varies, outlet water temperature change will be less than ±2℃ |
Standard Apply | CSA B125-98 ASSE 1016 EN1111 AS-4032.1 EN817, ACS, WRAS, ISO9001 |
Quality Guarantee | 5 Year quality guarantee |
- Q:Is the installation hole of the faucet used in the home kitchen the same? Are all 3CM? Will not buy a result not installed?
- Are the same, uniform standard (all interchangeable) faucet is the popular title of the water valve, used to control the size of the water switch, a water-saving effect. The replacement of the faucet is very fast, from the development of old cast iron to the electroplating knob, and the development of stainless steel single temperature single control faucet, stainless steel dual temperature dual control faucet, kitchen semi-automatic faucet. Now, more and more consumers to buy taps, will be from the material, function, modeling and other aspects to consider.
- Q:The kitchen with the faucet to buy back, but do not know how to install ah?
- The kitchen with the faucet to buy back, but do not know how to install ah?
- Q:Home kitchen faucet leak, please come to repair about how much money
- Home repair taps usually need about 100 yuan, the property if the provision of paid services estimated 50 or so.
- Q:This is the kitchen faucet, how can this move elbow removed? I can not afford to spin up to mention
- Turn the tightening nut down and tear it off
- Q:Kitchen faucet hot water small flow can not start the water heater, cold water normal. There is no clogging. Toilet water normal, how is the problem where the solution?
- How far is the water heater from the kitchen?
- Q:Kitchen faucet next to a pressure clean gel of the faucet, how to demolition
- First put your home water main valve hung up. And then turn off the water heater outlet valve. And then find a board, buy a new tube. Is it a few simple steps? When the rust is dead, If it is not tasting Han Bai Gan Fang imitation wet damp, then it would not be strenuous. Make a call called a plumber to three five in addition to two to get.
- Q:Kitchen faucet is 304 stainless steel is good, or copper is good?
- Now the taps are basically copper ah. Just plated with a layer of chrome, looks very bright, like a stainless steel. As long as no scrub like detergent, the faucet is not hair Ukraine. Note that usually use neutral water to scrub. It is hard to destroy the chrome-plated layer of the cat.
- Q:My kitchen with a gooseneck hot and cold two-way faucet, because there is no water heater installed, so the hot and cold water interface did not take the tube, but now, open to a direction, but never take the taps of the other exports of children Ephheng water, flow of a place, almost soaked something, consult a master, how is this? Welcome advice: Question added: Hello, first of all thank you for your attention to the news. This is the kitchen with the gooseneck two-way faucet, you can access cold water and hot water, because the water heater is not installed, so the faucet of an interface is not connected, only took a mouth, some time ago is good, but yesterday I found When I put the faucet handle to the cold side of the water when the other end of the tube did not take the other end of the water, and the water is not small, a lot of flow, do not know you can understand no, thank you faucet String of water Show the faucet bad? Repair, or re-buy a way? More
- normal phenomenon. The hot water interface with the baby powder drink bait for the madness of the town of Duke can be used to do the hydropower more than ten years, I installed the faucet, if there is no hot water pipe (or not), the beginning will be blocked on
- Q:Kitchen faucet handle rotation a bit tight how to solve
- Kitchen faucet handle rotation tightening method: This situation is generally caused by the handle below the cover loose, with the handle and the middle of the outlet pipe can be tightened clockwise. If it is tighten the cover can not stop the water, it should be sealed or spool wear, usually need to dismantle the new. Under the table under the leading installation bolts (or large nuts), from the next look to know how to disassemble. But before the demolition of the first turn off the valve or the main valve.
- Q:The hot and cold faucet of the dish is broken and how to repair it
- The core is broken, change the core, the handle has a screw on the first handle removed, and then find a big wrench to change the core on the line!
1. Manufacturer Overview |
| Location |
|
| Year Established |
|
| Annual Output Value |
|
| Main Markets |
|
| Company Certifications |
|
2. Manufacturer Certificates |
| a) Certification Name |
|
| Range |
|
| Reference |
|
| Validity Period |
|
3. Manufacturer Capability |
| a)Trade Capacity |
|
| Nearest Port |
|
| Export Percentage |
|
| No.of Employees in Trade Department |
|
| Language Spoken: |
|
| b)Factory Information |
|
| Factory Size: |
|
| No. of Production Lines |
|
| Contract Manufacturing |
|
| Product Price Range |
|
