Q:On my original PS3 power cable it says 10A 125V, do I have to make sure the cable I use from a computer matches the same?Also can you explain how it works if the cables don't matter

For the best answers, search on this site https://shorturl.im/avmLV yes you can due same due its only a cable

Q:Wire and cable manufacturing process (to be detailed)?

Copper core per square of the safe current (continuous use) for the 2.5A, intermittent use of 4A, according to the power count 550W-880W.

Q:Lets say in the CD-ROM, there's a song. And I want to play it but the CD-ROM's data cable isn't connected to the Motherboard.So even though the song can be played, I can't hear the music being played?* The Sata Power Cable is attached to the power supply *

The power cable will just power up the CD drive but NO music goes to motherboard and its sound port. Even just connecting the small audio connector between the CD drive and motherboard will produce sound output. Connecting the data cable to motherboard enables Windows to read and play the music files.

Q:I have a case that mounts PSU on the bottom. I find that I have to twist the SATA power cables 180 degrees to connect to the hard drives. Any tips? I was thinking maybe mounting hard drives upside down.

If the hard metal bit of the hard drive is pointed up, it's in right.

Q:So I have a subwoofer in my trunk and was wondering if I could use the big power cables (coming from my battery) going into the amp (which is a JL Audio JX1000) to power some LED's that I want to install. My plan was to cut out a small section of the rubber sheath (or whatever you call it) from each power cable and put the clamps from a power inverter on them, then plug my LED's into the power inverter. After putting the clamps on I would use electrical tape or something to cover any exposed areas of the cable. Would this work? If it does work, which color clamp (black/red) would i put on which cable? One says quot;groundand is blue and the other says quot;+12VDCand is red. Also I have a toggle switch near the driver seat to cut the power from the amp so the LED's won't be left on after the car is turned off. Let me know if I'm leaving out any further information needed to answer my question.

You okorder /... Your power inverter, I am not sure what kind of cabling it will require for it to be powered properly as well. Ground is usually connected to Black. And +12v is usually Red.

Q:My laptop power cable is bust and i need a new one for my Acer laptop, please can someone tell me where i can purchase one?Thankyou very much!

you may get them from Dell quite exspensive ?50 plus, or you may get considered one of OKorder for around ?18.00 My daughter had a similar concern together with her capability unit. Dont choose for the cheap one for around ?4.00 ineffective

Q:im looking to put a switch into the power cable for my amp so that it i can turn it on and off. what is the best way to do this? cheers

Why not just put the switch on the remote blue wire? After all tht is wht turns ur amp on.

Q:Is it? I leave the power cable for hours when at home, when letting it process video and such and sometimes drain the battery when not used much.Thanks for any help.

It isn't good to overcharge a Li-Ion batter, but some devices/batteries are better than others at preventing damage even when there is a continuous supply of power. I'm assuming it's a lithium-ion battery. If it isn't you need to throw your laptop away and buy a new one with a li-ion batter :) On a more serious note, it probably isn't GOOD for it, but it isn't TERRIBLE either. They say that li-ion batteries aren't susceptible to memory loss, but that is debated by people who actually use the device. However, li-ion batteries WILL expire after being charged a certain number of times, so it is best to allow it to (almost) fully discharge before recharging. When you notice that it's fully charged, go ahead and unplug it if possible, and when you need it to charge, just plug it back in. But I'm no battery expert, so your best option would be to call a computer store (or battery store) and ask them. Or perhaps there are some battery experts browsing Yahoo answers tonight?

Q:its 6pin power cable on vga if we went really connect to psu if i not connect to that it ll happen something ?if i want to connect psu or mother board?

The question was not making sense to me. 1. If you wanted to know if you wont connect any power cable to the video card will it work. No It will not work. The video card has its own power requirement hence it has to be connected to six pin PCIe power. If you don't have one of those in your power supply then then you have a molex to 6 pin power connector. 2. If you want to know if the PCI'e power connector canbe connected somewhere else the answer is no. 3. The graphic card can only be installed in PCIe X16 slot. Hope it helps Rocky :)

Q:can i run a ati radeon hd 2900xt with a two 4pin molex power cable?

yes of course