Q:I think it's impossible! This is surely a stupid question, it just doesn't explain it anywhere. Are they stuck in there?

smash it open with a hammer. it will work :)

Q:1.5v 1 battery 4 how to splice into a battery pack?

First calculate the power and current through this resistor to derive the actual power, and then buy a power factor of 1 ohm higher than the actual power you calculate.

Q:I really want to get an EnV touch but i've heard bad things about the battery not lasting + everything.Does anyone know where to get an extended battery pack? [is it at the verizon store?]and how much it costs?Thanks so much(:

I would recommend buying from amazon web site.Things on there are cheap.

Q:I was just wondering, if I were to take apart both a rechargeable battery pack and a normal AA battery pack, would I be able to replace the back of the rechargeable one with the back of the normal AA one? I have a normal AA pack with a design on it that goes to my controller shell, but I don't want to keep replacing batteries in it, and I don't really want to just go buy rechargeable batteries when I have a bunch of spares for this kind of thing sitting around collecting dust.

tricky step try searching from a search engine that might help

Q:I have a device that used an internal, rechargeable 12v battery pack. Since the device is no longer needed, I was thinking of taking out the battery pack and using that to power other devices. And recharging it with a solar panel.Since the battery pack isn't a single 12v battery, but made up of ten 1.2v batteries connected in series, I am not sure if I would need to connect 12v solar panel to it through a charge controller. I have a 12v charge controller, but since each battery in the pack is 1.2v, would the regulator automatically adjust so the individual batteries arent overcharged or may explode?I also have 2 side questions for you.(a) To make my own battery pack, what would I use to melt the PVC shrinkwrap so it would fit snuggly around the batteries?(b) And if I wanted to solder the tips of each battery, would using a solder iron cause the battery I'm soldering the wire to to explode?

You would need some type of charge controller since it is very unlikely that you can find a solar panel that has the exactly correct voltage output. In addition, NiCad and NiMH batteries should not be over charged. You're not going to find an off-the-shelf charge controller that will balance individual 1.2 volt cells. Most consumer grade devices that run on small rechargeable batteries don't provide that feature anyway. For question (a), a heat gun is used. They look like traditional hair blow dryers, but are much hotter, with the temperature controlled by a dial. For question (b), no, a standard soldering iron isn't going to cause a battery to explode. However, the metal for the batteries usually cannot be soldered. When battery packs are made the tabs and other connectors are attached using an electric spot welder. If you can get tabbed batteries, that would be the way to go.

Q:i have heard i have to buy a cooler, a rechargeable battery pack, what is absolutely necessary and what's not?

nothing is super necessary, but the intercooler really helped me out, because my 360 would always over heat and freeze up and now with the intercooler it only does it every once in a while. The rechargeable battery is nice to have but if u have that then u need a charging station or a play n charge kit. the only reason its nice to have is that u dont have to keep buying AA batteries

Q:i hvae att and i want to put my sim cardinto my dad's iPhone. but neither of us know how to open upto the battery sim card area. does anyone know how?i've asked like all my friends and everyone haha help!

Use a paper clip on that small hole on the top of the iPhone. The SIM card drawer will slide open from there. You can't access the battery at all.

Q:How much battery life does a flip camera battery pack have when fully charged?

It depends how you use the camera, what video quality option you selected in the camera and a few other items. In the Flip's manual there is a table that shows how long the battery will last This information from Flip is also helpful (scroll down a little) www6.nohold /CiscoFlip/ukp.asp

Q:Hi. I just brought the Xbox 360 Play and Charge Kit for my wireless controller. This kit works when the console is turned on, or when I'm playing a game. However, how can I charge the rechargeable battery pack with the play charge kit when the Xbox 360 is turned off? Also, what colored lights should I look for to see if the battery pack is being charged, or done charging?

Yes you can for being plugged in the xbox always has a power source. also orange i believe is charing green is finished charge.

Q:I found a 4800 mAh battery pack for sale but wanted to know if anyone has or can fine a more powerful battery pack?any help is greatly appreciated

The Xbox 360 Rechargeable Battery 2-Pack is perfect for any gamer who goes through battery's like crazy, or even not, The Rechargeable battery packs are perfect if you are looking for a spare or 2 packs to be on the charger at all times, ready for you to exchange them out in the heat of the battle. The only reason I give a 4 is they gave me a bit of trouble at first charging wise, but it's all fine now. In the end I highly recommend this product for anyone who is looking for more battery packs. If you have any questions comments or concerns, please comment below.