Q:I have my old 350 power supply cable but i got a new 520 one. do i have to use the defuly 520 power suppl cable? i use my old cabbke

No, as long as it can supply the proper voltage and amperage.

Q:It wont do any damage will it?

yes you can and it will be fine, my 8 pin connectors had clips on the end so i could remove 2 pins and use it as a 6 pin...

Q:My pc don?t start, power cable and all other cables are connected correctly. Any body help me and guide me?

Before okorder /... Replacing the Power supply is pretty straight forward.... just undo the screws at the back of the casing, and it slips out from inside. Put the new one where you took the old one out, and swap the leads over (matching like for like). One thing I have noticed both times I've fitted a Power Supply is that the screw holes in the back of the Power Supply never, ever line-up properly with the screw holes for it in the back of the PC Casing........ found the trick to doing it is to loose fit the screws first (might need to go in at an angle), then tighten them all up and it'll line up properly like it's supposed to.

Q:i have an hp7500 and their is only two pin spots on the 9400 cable

Huh? Do you have the right model #? The only cable on the 9400GT should be the fan cable, and it should plug into the card itself (see picture in the link)

Q:remove just this cable or use different hd and it works fine, is the hd broken or is it a power consumption by the hd issue? tryed a different psu and its the same problem, unfortunately not got another pc handy to check the hd on. Thanks In advance?

change the hdd interface bus u may get solution otherwise replace it. .in

Q:I need a cable to connect my SATA hard drive to my computer's motherboard (which already has the SATA ports). Is this the correct cable:

Yes. You will also need to power the SATA drive, so if your power supply doesn/t have the right connectors it, you will need an adapter.

Q:What is the difference between a photovoltaic cable and an ordinary cable? What is the structure of a photovoltaic cable?

The structure of the PV cable is shown in the table. The difference between the ordinary cable and the PV cable is analyzed: The common cable can be seen from Table 1 that the conductor and the PV cable used are consistent. ordinary cable insulation and sheath can be seen from Table 1 different from the photovoltaic cable. Ordinary cable is only suitable for use in general environment. the advantages of photovoltaic power cable: high temperature, cold, oil, acid and alkali salt, anti-ultraviolet, flame retardant, environmental protection, photovoltaic power cable is mainly used for harsh environment, the service life of more than 25 years.

Q:for any SATA 2 HDD, the power connector is longer. compared to the data transfer cable. wht is it so?,-------------- ,------the first set of lines represent the power connector second; the data connection cable.

at the same time as you're meaning are you waiting to boot off of the IDE stressful stress and get get admission to to the Sata stress, the answer is for particular. really connect the SATA stressful stress, and make positive the BIOS settings are set to boot from the IDE stress.

Q:I have my Clearwire modem but have lost the power cable. Does anyone know what I would look for in a replacement power cable.

Take your modem with you to an electronic store and find a matching cord. or call the manufacturer for a replacement.

Q:HiIs it advisable to run 110VAC cable from the sub stationa and 110VAC cable from generator (clean) in the same conduit ; one of them for lighting and the other for CCTV; the concern is if the one for lighting is not clean (not consisting of a pure sine wave or carrying interference) would that effect the power line of the CCTV and has an effect on the picture? even though both are 110VAC.the installation is over seas where the power from the station is not consistence.

if the two are not shielded from each other they will cause interference... run two seperate metal conduits,, or use shielded AC cable in the same conduit ,, ground the shields and the conduit!!!