Q:The number of lights in the LED string

15 lights, 30 lights, and 60 lights refer to the LED band. How many LED components are welded per meter length?

Q:Section LED lantern, no controller, can shine principleTwo now reduced brightness string string

Led 2 polar tube inside chip oscillator circuit, and the general appearance led 2 polar tube without distinction, only connected to the power supply of two kinds of color turns light, 1 seconds, I bought the 5MM red, blue autoflash. From the appearance of the series, but not necessarily in series

Q:Rated voltage of LED lamp string

When normal luminescence, each LED voltage drop is more than 2 volts, the current is about 15mA, to use 220V direct current should be connected in series with nearly one hundred led, or in the LED circuit series resistance, so that the series circuit current is about 15ma.

Q:Hanging on the tree string lights, each one is 10 meters long, with a controller, I asked the factory with the AB protection, but the manufacturers say that only do the general anti rain, no water, even the rain stop, I want to use plastic wrap, don't know? Which expert can give advice and advice? emergency

There are grades of waterproof and dustproof, and the methods from 0 to 9. are different!I think you should use, can prevent the rain, and shallow water immersion!This is easy to handle. When the controller is made, if it has a shell, touch 703 glue at the joint! General circuits are frequently usedIn fact, many LED production plants have LED filling glue and waterproof!

Q:220vled water lamp string how to connect, that is, 220 of the electricity

The time of the water lamp is controlled by adjusting the capacity value of the capacitor.

Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!

You can use the 4~6V battery, through the 4W, 2~3 Europe (6V with 3 Euro, 4V with 2 Euro) current limiting resistor, to the LED lamp power supply. The parameters of each lamp are: 3V, 20MA, in parallel (polarity). If you don't quite understand, you can also ask a science and engineering student (preferably a teacher) to help.

Q:The color temperature of LED light string

Light source temperature is different, light color is also different:The color temperature is below 3300K, the color is red, and gives a warm feeling. There is a sedate atmosphere and a warm feeling.The color temperature is in the middle of 3000--6000K, and there is no obvious visual psychological effect in this hue, and there is a refreshing feeling. It is called neutral color temperatureColor temperature exceeds 6000K, light color slants blue, give a person with cool feeling, commonly referred to as cool color temperature.

Q:How does the LED light string flash?

Because of the special volt ampere characteristics, LED can not use constant voltage driving mode, but is driven by cross flow. The direct drawback of cross flow drive, however, is heat. So people invented the drive mode of pulse drive. For example, 0.5 seconds per second, so that the amount of heat in the LED is reduced by half. Then turn the frequency up to 100 times per second, lighting for 0.005 seconds each time. At this point, the power of the LED is not the same, and people do not feel blinking. What's more, in this driving mode, an approximate cross flow drive (that is, the current is not necessarily precise) can be simplified, which simplifies the drive circuit (the precise cross flow source is very complex)

Q:Why are there three lines for the controller of the LED light string? What are they?

The four cycles are green, blue and white, and the answer is almost the same as that on the top. But the three colors are strung together

Q:Performance and characteristics of LED lamp string

1.LED lamp string can handle perforation lamp string processing;2.LED lights string may through seven colors and full-color controller to achieve colorful jump, gradient, monochrome, full-color, fluttering and other effects.