Q:i replaced my ps2 power ribbon cable with a slightly diffrent ribbon cable but it had all the connections just like the original one. i plugged in my ps and i heard that slight clicking sound of the electricity entering the ps2's cuircut such as it always has when it was working fine. but when i plug the ps2 in the lights on the power buttons wont come on and they havent come on no matter whitch way i turn the cable. i would really like to get back to KH2 bugt this is getting annoying. what is up with my ps2 that even though everything is connected i cant seem to get the power lights to come on. help!

reassemble it again .pull out out the power cord and reattach it .it happened to me and thats what i did

Q:I have a be quiet! dark power pro 850W. The sleeving is too thick for cable management!! It is a complete mess with the antec 900. its ridiculous as I bought it with cable management in my mind. Can I buy thinner cables on their own? Is there a standard modular fitting size?Thank you.

the capability connectors that plug into the slots on a modular capability furnish are no longer common -- they are particular to that distinctive style of furnish (there is a few standardization for modular PSUs made by a particular producer, yet i does no longer even confirm approximately that). So, in case you opt for further cables, you ought to touch client service on your style of PSU or examine help boards at their internet site to work out what the technique is for paying for them.

Q:I don't want to run it under the car, but I can't find a place to run it through the firewall... Do I need to drill a hole?

I think you need to look at what ever is going through the fire wall first. often you will find things like speedo cables and other cables that go through it using a grommet, if they is a 8mm plus one used you could puch your power cable through the same grommet, this will save the drilling but if you do have to drill use a grommet to seal the hole, it costs only cents.

Q:i have a 2001 corolla with a new amplifier. when they wanted to test the amp after all wiring was done, they somehow wired the amps power cable to my negative connection on the battery. i turned on the electrics on the car and they all work. then i tried starting it, and how the engine wont start and the lights dim when im turning the key. what happened? and how can i fix this major screw up???

If the electronics work, then it's not the battery, Hooking up the power wire the ground does nothing, there isn't a circuit to complete, without power. Even the remote turn wire, having power, would either put the amp into protection, or pop the fuses...Does it try to turn over? or if not, does it have a starter solenoid?

Q:i bought a car from some guy..he had 2 amps but he took out one...he had the power cable running from one amp to the other. i just recently bought another amp and i was wondering if its safe to do this.he said it was working fine..he was powering 2 10 subwoofers..thats what im planning to do

its safe but its better to run 2 separate wires due to you are wanting to use more power and one wire has a max load that it can handle...you run 2 and you will have more power to each amp

Q:Will it work if I put a pigtail (connect the wires by twisting them together) or does that stop it from working properly..

That would not be wise. Alot of power is traveling through that cable. Chances are you might fry your laptop or start a fire. Just go buy a new cable

Q:I've had this laptop (Dell Studio XPS 1640) for about two and a half years, and I've been through three power cables. The first one was a no-brainer, since the end was wearing a lot and you could see the wires. The past two have basically just stopped working for no obvious reason. The blue light on the end of the cord still lights up blue, but my computer says plugged in and not charging. I just bought a brand new one less than four months ago and it's worked perfectly until this past week. Has anyone else been having this problem with similar laptops? And if so, is there anything I can do besides wasting more money on a new cable?

I would suggest your take your adapter in to your local computer store and they can check it out. If your adapter is working but your still not getting current then the problem is inside your computer and it will need to be sent for repairs... Source(s): CompTIA A+ Computer Professional

Q:If I buy a PS3 in the US and bring it back to France, if I buy the french power cable and exchange it with the US power cable, will the PS3 work? I have a transformer which I already use for my Wii so if the power cable doesnt work for the PS3, I can just use the transformer.

Yeah it should work mate

Q:I have a power cable for my computer that got slightly chewed and i was wondering does that effect the power.im just wanting to know if it will have less power or will it work the same and as far as i know none of the wires where hurt just the rubber around them.

replace your cable as its now a fire and shock risk

Q:There are a few thin cables running from the power button on your computer onto the motherboard. What are these cables called?

Go to pc repair shop. And ash them.