Q:What are the kinds of led lamp holder?

LED lamps and lanterns of species LED lights, LED street lamp (Light Emitting Diode, Light Emitting Diode) the semiconductor lighting. It is a kind of based on semiconductor PN junction formation with a weak electricity can glowing efficient solid-state light source, in certain positive bias voltage and the electrical flow injection, injection of holes and injection P N the electronic after spread to have source area by the radiative recombination and emit photons, convert electrical energy directly into light energy. It is a solid cold light source, green pollution-free, less power consumption, high photosynthetic efficiency, long service life, therefore, the LED street lamp will become the best choice of the road lighting energy saving reconstruction. LED project-light lamp, LED project-light lamp make specified by the intensity of illumination on the cliff above the lamps and lanterns of the surrounding environment. Say again the spotlight. Normally, it can aim at any direction, and has not affected by the climate conditions of structure. Mainly used for large-scale operations in mining, building outline, stadium, overpass, monuments, parks and flower beds, etc. Therefore, almost all the outdoor use of large area lighting lamps and lanterns can be seen as light. LED wash wall lamp, LED wash wall lamp, as the name implies, let the light like water washed metope, mainly is used for building decoration lighting, and used to draw the outline of the outline of a large building! Due to the LED energy saving, high photosynthetic efficiency, color is rich, long service life etc., so in 2013 other light source to wash the wall lamp is gradually replaced by LED wash wall light.

Q:Led to shoot the light, the 12 v transformer and transformer can general ordinary lamp?

Transformer are interchangeable, but LED is a dc power supply, if the pressure after the bridge rectifier, more than 12 v, also need to consider the LED string and method and current limiting resistor.

Q:What is the difference between LED GU10 and ordinary lamp

Tube light is usually thought to be installed in the ceiling, condole commonly need over 150 mm to pack. Of the canister light, of course, there are external type. In the absence of dome light or droplight installation tube light is a good choice, relative to shoot the light wants downy light. Shoot the lamp to be generally can be divided into orbit type, hanging and embedded, etc. Shoot the light with transformer, but also have without transformer. Embedded within the lamp can be installed in the ceiling. Lamp is mainly used to emphasize or performance, such as TV wall, hang a picture, accessories, etc., can play the light rhyme to enhance the effect

Q:Shoot the light is led lights

Shoot the lamp to breed a lot, the main characteristics of the LED energy saving energy saving, long life, low fever, healthy environmental protection, high color rendering, not easy damaged, you can see on taobao VNC domestic brands to shoot the light, we are using there, has the certain quality assurance

Q:Cob lamp and led lamp that electricity consumption big?

I don't know your philips lamp is incandescent lamp, halogen tungsten lamp or fluorescent lamp so introduce with you: r n incandescent lamp, halogen tungsten lighting effect for 12 to 24 lumens / tile, fluorescent lamp, 50-70 lumens / tile, sodium lamp lumens / 90-140 watts, most of the electricity into heat loss. LED lights can be sent to a 90-100 lumens / tile, through the data you can work out! The hope can help you!!

Q:Motorcycle lens and the LED lamp can be installed at the same time, and shall not affect the circuit?

You increase the total power of about 155 w these lights, has exceeded the design of the general domestic 35 w, even though the battery, ignition key switch and headlight switch contact capacity is limited, so the best way is to add headlight relay, let the headlight received battery anode current directly through the relay contact, ground also another bold lines; Relay coil by the headlight switch control in order to extend the life of the ignition key and headlight switch contact, can avoid and round headlights lines within the original wire resistance pressure drop, and its heat. Small appliances is the electromagnetic switch, coil current through the magnetic drive large current contact, such as selection of 12 v dc relay contact current for 15 ~ 20. A, you can load 180 w ~ 240 w lamps. Also have to consider your motorcycle engine and rectifier charger whether can satisfy the requirement of the 20 ah battery charging, so as to avoid the battery often lose electricity scrap.

Q:What about the size of the led light?

Size of the LED lamp Are generally as the lamp wattage increases with the increase. The general 3 w hole between 60 mm to 85 mm, according to the wattage increases with the increasing.

Q:Led lamp and cob light which is suitable for hanging the sitting room

Domestic outfit may generally don't have to shoot the light Generally canister light is good Decorate need lamps and lanterns can look for me I do wholesale of lamps and lanterns of home outfit have a lot of money

Q:The 35 w to shoot the light with 3 w LED is not lit, use need not change the transformer?

35 w lamp has two kinds: one kind is 220 volts, no transformer. This cannot be used directly to get dc power LED bulbs

Q:Led lamp can adjust luminosity

Is can make color of LED lamps and lanterns that move light, only the promise of dimming color LED drive power supply line,