800-1800KW China JDEC Generator desiel 600

Ref Price:
Loading Port:
Payment Terms:
Min Order Qty:
1 unit
Supply Capability:
1000 unit/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:


This Generator powered by cooperating with AVL 


ModelEngine ModelRated Power (KW)Standby Power (KW)


power (kw/r/min)

FUELL×W×H (MM)Weight (KG)

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Off Grid power options?
i don't know about your possibilities where you are but i would definitely suggest using as much natural lighting as possible and the alternate wood heating furnaces available
Q:how to compare efficiencies for a diesel and a diesel-electric engine?
Very similar to comparing Apples to Oranges. Diesel Engine provides mechanical output. When connected to a Generator it becomes Diesel Electric with Electric out put. In terms of efficiency you rate the Diesel, the coupling and the Generator power factor to rate efficiency.
Q:power generator for home use?
GENERACHas a 25 kw that uses natural gas.Also packaged units that start on power failure We have a 600 kw that is nat. gas and isn't too hard on gas
Q:Can you pass legislation to mandate diesel fuel saving devices that are available on the market today?
there's a narrative in in the present day's new york cases correct to the EPA attempting out hundreds of those products and located that the few that do artwork, do not artwork nicely sufficient to justify the value.
Q:Diesel Generator Welder current question?
DC is desirable, but not necessary for stick welding steels. DC produces deeper penetration in most cases. However AC can be used for stick welding just as well. AC is actually better when welding with E7024 rods. AC welders tend to be very robust because they're incredibly simple, basically just a x-former or alternator, a large rheostat, and an overload protector. DC systems are a bit more complicated. Fortunately, the machine in question seems to have 110V 15A outlets for residential-type power, in addition to the welding outlets, which are 75 volts on open circuit. Machines used for stick welding are of the constant current (CC) type. That means that the applied voltage will vary based on the resistance in the arc. Note that MIG welding uses Constant Voltage (CV.) (The current in MIG welding largely depends on the wire feed rate.) Residential current outlets also need to be constant voltage, not CC. How much welding experience do you have? A year or less? With due respect, perhaps you ought to be asking some of your customers for advice, not GIVING it to them.
Q:What are the procedure of pre-start up of AC generator?
Before check all fluid levels and turn off all breakers before starting or stopping!
Q:is the chinese air craft carrier powered by diesel engines or a nuclear reactor?
I got both in my f350 super duty with 17942 horse powers that will pull an air craft carrier straight out of the ocean
Q:Why would someone say that a GENERATOR can run on BioDiesel ??
if it is a diesel powered gen set it could run on bio fuel as long as it has been processed correctly a diesel gen can run on several different types of fuel
Q:Fitting Carbon neutral generator to an RV any advice?
Electric heating of your hot water is very inefficient since you have so much heat rejected in the exhaust for every KWHr you make. Your best bet would be to use the exhaust heat and/or jacket cooling water from a biofueled generator to heat the hot water tank. You get very high efficiencies from that combination. I have seen such devices talked about (see the link below) for years, but have recently seen one that is actively under development. It may be a bit oversized for your RV, however, since it is for a house. You may be able to just add a heat exchanger on the exhaust and use a small, thermostatically controlled pump to circulate the hot water from the tank through the tubes. Biofuels are not as available as gasoline, but if you research where you are going, you may find they are more prevalent than you think. Also, the generator will be able to run on fossil fuels as well, giving you a back up in case you can't find biofuel. Hydrogen is interesting, but I can't think a commercially available generator that runs on it. And you would still have the efficiency issue unless you recovered the exhaust heat like I have said for the biofuel. I can't think that solar would work well, you have such a limited amount of collection surface on the roof, and lugging around batteries and/or hot water is also inefficient. I have been on trips where it was cold and cloudy for a week, solar would not do well under those circumstances.
Q:What generator should i use?
Cheap as possible - go Chinese if you want to use it once a year and don't care if it goes paf at any time. Honda makes some good units if you want quality and back up. You need to add up the power draw of your five normal applications and your 600w lighting load. Add 25% and the unit will be adequate. If your appliances have induction motors you will have to have at least three times the rated power of the motor(s) to get them to start safely. If you need more than 3000 watts of constant power you should consider diesel, for longevity go for slow speed i.e.1500 or 1800 rpm engine speed. Price will range from $400 for a 2500w Chinese thingy up to at least $14,000 for a fully enclosed automatic 12KvA super silenced slow speed diesel unit on a slide. Running costs get high with the bigger petrol units. Inverters are good, but you will still have to generate power some how for the batteries - wind, water, solar, generator etc. Will be more expensive to set up but will be better long term for a cabin or similar. I'll tack on a couple of links below. Good luck.

1. Manufacturer Overview

Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range