Q:How to laminate the floor?

Third floor, seven install, it can be seen, how to shop composite floor, composite floor, how to shop is a very important thing. When the floor in the shop when the floor, should pay attention to what? The following is the sub-Aubian Xiaobian summary of the pavement composite floor when the main note: 1, guard pole Gua Gua Gai Ge Geng Kung grass base should be smooth, solid , Dry, clean, non-polluting, strength to meet the design requirements. 2, in the bottom of the building or cottage pavement to be moisture-proof treatment. 3, to strengthen the composite floor pavement, the indoor temperature should be in accordance with the provisions of the product specification requirements. 4, the bottom of the floor should be full of moisture at the end of the pad, pavement formation, seams can not be laminated, and fixed with tape. 5, the installation of the first row of the floor when the groove should be facing the wall, between the floor and the wall left about 10mm gap. 6, the room length or width of more than 8m need to set the expansion joints, install the pressure bar. 7, wooden skirting board with 45 degrees groove tight adhesion, height, wall thickness of the same, fixed nail cap is not exposed. 8, the surface straight, color, grain coherent, clean without glue marks.

Q:After the wooden floor is installed, it is much higher than the original floor, and I know that the tiles are at least 5 centimeters higher than the original ground. More

Almost 5 cm, because the floor and tiles to be flat.

Q:My home decoration is Chuang floating off spring curled turtle Tong Tong Kun light-colored composite floor, so the floor seam a little bit of dirt, then it looks black, with a mop can only rub the floor, clean the floor seam, I have tried With a wiping cloth wrapped with a finger of a seam of the pull, so the floor is a clean seam, but did not rub half of the tired half. Do not you know that there is no merit to solve this problem? The More

You can put a little detergent to dilute the brush with a general brush can be a soft brush and then wiped out the red float spring ripe turtle Tong Tong Kun is a rag can be dry. This method will not cause harm to the general floor. I believe that I do floor business. Remember to give me points ah

Q:Do you want to remove the original floor? Decoration company will take this little work? More

The amount of floor is very simple. Find a worker on it. To be removed.

Q:We're putting in an engineered floor in our kitchen and are trying to decide whether to staple or glue it down. There doesn't seem to be a preference from the manufacturer's information, just instructions on how to do either one.

Glue and staple do you want floor to squeak because you were to cheap to buy ten dollars worth of staples and glue I have heard a floor squeak very bad because someone was too cheap to buy glue staple also because glue may not stick everywhere

Q:Is Ok to wax engineered wood floor?

Check out this website

Q:My family for many years before the shop floor of the solid wood flooring taste of bamboo stalks mixed when the full river, and now some places have been blisters from the drums. Now someone in order to pursue foot feeling, want to shop in the solid wood flooring directly on the floor, consult experienced friends, so what is the problem? (My home in the north, 9th floor) Also, if the demolition of solid wood flooring, re-leveling the ground, with a good cement or a big board? Thank you so! Question added: if the solid wood over the shop, how much higher than now? My house is only 2 meters high. More

You like this is the best way to get rid of the original solid wood flooring and then pave the way to taste the white straw when the fiber is mixed with full. There are two reasons: 1. Solid wood flooring with the time for a long time prone to sound, keel between the gap which is easy to filth, and if the original solid wood flooring is not smooth in the above and then the floor composite flooring easy to ups and downs, loose. 2. Your current room is only 2.6 meters high, remove the solid wood flooring and then shop composite floor to clear the ground leveling, to save about 3-5 cm of space. The ground to re-leveling or cement with good, or self-leveling can also be.

Q:Has anyone worked with Bostik EFA for installing an engineered floor? Is EFA better than Bostik Best?

Bostik Best is the premium adhesive in the wood flooring industry, also the most expensive. You should look at Mapei 980, or Taylor MS Plus adhesives for a lower cost option.

Q:When the composite floor assembly can be card into the side slot

Natural assembly, that is, short side without the need for sewing can effectively reduce the waste, but personally think that the premise of composite floor for the general strengthening of the floor, no chamfer; if the imitation of solid wood flooring (surrounded by V-shaped, U-shaped chamfer), personal recommendations To the short side of the seam to install, or light blindly pursue the reduction of waste, the effect of pavement slanting short cup of tea is very ugly. In short, the ordinary composite floor can not be installed on the seam, the smallest waste, imitation wood flooring on the seam to install a small waste is thirty-six type, the middle of the seam to install a relatively large waste, but the pavement effect personally think the best. Oh, if the landlord's room is not shaped room, then the general floor loss of about 3%, no more than 5%, if more than 5%, and the landlord will have a good theory with the construction side, of course, But also with the construction side to communicate, to be aware of, after all, can not put the cart before the horse, blindly only to reduce the waste and ignore the pavement effect. Under normal circumstances, the construction side of the installation master will tell you to install the way, I wish good luck, ^ _ ^

Q:Recently to my house for decoration, I now tangled in the shop solid wood flooring or floor tiles. I heard that the solid wood composite floor of the viscose contains a lot of formaldehyde, and three or five years are volatile, but I also like the twitching of the defensive flossing gong skull Geng Gong wooden floor feeling. Solid wood floor even if the price is too high to take care of, give up directly. What should I do in the end? Hope that people of insight can give pointers one or two, grateful! More

In fact, it is possible, mainly depends on the needs of the landlord. Because they do not understand the specific situation of the landlord, can only probably say the next proposal: First, the proposed floor: because the floor is warm, the tile is cool! With the intimacy of the tile worse than the floor! At the same time, the cost of laying tile is better than the floor of the floor is not cheap; Second, the specific solid wood and composite or strengthen the specific situation depends on the specific treatment. I tell you the situation, you judge it ~ solid wood, and solid wood composite: good environmental protection, wear resistance, paint to be regular maintenance, high cost of solid wood, the north is easy to crack the deformation of the crack. Solid wood composite cost is moderate, the structure is stable, suitable for geothermal. Strengthen the composite: environmental than the solid wood is poor, pungent and durable, high wear resistance, easy care, low cost, high stability.